Automotive Hot Tub Steps with Two Handrails Instruction Manual

Automotive Hot Tub Steps with Two Handrails

Product Specifications

• Number of Brackets: 2
• 0.8 Screws: 8
• 1.4 Screws: 22
• Number of Step Panels: 4
• Number of Mats: 4
• Number of Grab Bars: 2
• Number of Grab Bars Connection: 4
• Number of Triangular Bars: 8

Product Usage Instructions

1. Prepare Two Brackets
   • Ensure handrail holders face outwards.
2. Install the Upper Step Panel
   • The widest panel with 8 holes should be used. Ensure that 1.4 screw heads face outwards.
3. Install the First, Second and Third Step Panel
   • Pass a 1.4 screw through the bracket, triangular bar, and pre-drilled hole on the respective panel. Tighten all three components together.
4. Install Two Back Triangular Bars
5. Install the Two Handrails
   • Insert the handrail into the holders and use 1.4 screws to tighten from the holder bottom.
6. Put on Mats and Tighten All Screws
   • If needed, use a 10mm drill bit. For four-step panels, ensure all screws are first placed and then tighten them one by one to avoid any missing screws.

Warm Tips

1. For four step panels, Please get all screw son first, then tighten them one by one. Or else some screws may not be screwed in.
2. There are four 1.4″ screws to tighten the hand rails, please screw in from the holder bottom.
3. Please double check if all screws have been tightened before stepping on.
4. Please don’t shake the hand rail sor jump on the step to avoid dangers.

Frequently Asked Questions

• Q: What should I do if some screws are not properly screwed in?
  • A: For four-step panels, ensure all screws are first placed and then tighten them one by one to avoid any missing screws.
• Q: How many screws are required to tighten the handrails?
  • A: There are four 1.4 screws provided to tighten the handrails. Please screw in from the holder bottom.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>