Alveo3D A500 Wireless Photoelectric Fire Smoke Alarm User Manual
- June 1, 2024
- ALVEO3D
Table of Contents
Alveo3D A500 Wireless Photoelectric Fire Smoke Alarm
Wireless Photoelectric Fire Smoke Alarm
Technical Parameters
- Working voltage : 3V
- Standby current : ≥ 5 µA
- Alarm current: ≥ 600mA
- Battery specification: 2 AA batteries
- Alarm sound: ≤85dB (within a range of 15cm)
- Wireless frequency: 433.92MHz
- Range : up to 100m outdoors
Product Description
Recommended Installation Locations
The Alarm can be installed on the ceiling or obliquely; If it needs to be installed on an inclined or rhombic roof, the inclination angle should not be greater than 45°, and the distance is preferably 50cm.
Install
-
Turn counterclockwise and open the hanging board
-
Remove insulation sheet around the batteries.
-
Fix the hanging board to the ceiling.
-
Clockwise, secure the alarm.
Usage
Function 1 : Alarm if smoke is detected.
Function 2: Test detector Press the red key to test the alarm.
Usage 1 : Independent alarm.
Usage 2 : Paired detector with an electric socket,
wireless transmission (needs to be used with RF433 hosts).
Wireless Remote Control Socket
Please read the instructions carefully before using the product.
Pairing the Socket with the Smoke Detector
-
Plug the socket into the power outlet. Press the side button of the socket until the red light flashes, then release. The light should continue flashing.
-
Activate the detector’s test mode by pressing its red button.
-
If the socket light stops flashing, pairing is successful
-
Check the pairing: arm the socket with its side button and activate the detector’s test mode. The red light should turn off.
-
To pair one detector with multiple sockets, repeat steps 1 and 2 for each socket using the same detector.
-
To pair multiple detectors with one socket, repeat steps 1 and 2 with each detector, using the same socket.
