Alveo3D LED30 Remote Controlled LED Strip Instructions
- July 16, 2024
- ALVEO3D
Table of Contents
Alveo3D LED30 Remote Controlled LED Strip
Product Information
Specifications
- Dimensions of the strip: 300 mm x 270 mm
- Maximum power: 12 W
- Voltage: 24 V
- Maximum intensity Connector: 0.50 A DC male 5.5 x 2.1mm
- Battery type for remote control: CR2025
- Remote communication: Infrared
Product Usage Instructions
- Stick the LED strip: Peel off the adhesive tape on the back of the LED strip and stick it to the desired surface.
- Connect the LED strip: Connect the LED strip to the infrared (IR) receiver on the LED side.
- Connect the IR receiver: Connect the IR receiver to your power supply.
- Control the light intensity: Use the remote control to adjust the light intensity by aiming at the IR receiver.
Safety Instructions
Coller le bandeau de LED sur une surface plane.
Contact Information
For technical support, visit www.alveo3d.com or email contact@alveo3d.com
FAQ
Q: Can I cut the LED strip to a shorter length?
A: It is not recommended to cut the LED strip as it may damage the product and void the warranty.
Q: How do I change the batteries in the remote control?
A: To change the batteries, locate the battery compartment on the back of the remote control and replace it with a new CR2025 battery.
Remote Controlled LED Strip with Infrared Remote Control in 24V and Self- Adhesive
KIT COMPOSITION
KIT COMPOSITION of the Remote Controlled LED Strip
LED Strip, Infrared Remote Control, Infrared Receiver, 24V Power Supply, Cable Extension
USAGE of the Remote Controlled LED Strip Kit
- Stick the LED strip to the chosen surface using the adhesive tape on the back of the LED strip.
- Connect the LED strip to the infrared (IR) receiver on the LED side.
- Connect the IR receiver to your power supply.
- Control the light intensity using the remote control by aiming at the IR receiver.
Safety Instructions
Coller le bandeau de LED sur une surface plane.
Stick the LED strip on a flat surface. At full power, the LED strip gets hot. Do not touch the LED strip while it is powered. Do not stick the LED strip to materials that cannot withstand heat (>80°C).
TECHNICAL DRAWING
IR Receiver: DC Female Plug Connector, 2 mm
IR Remote Control Functions:
- ON/OFF
- 3-Level Power Adjustmentaux
TECHNICAL CHARACTERISTICS
| Dimensions of the strip | 300 mm |
|---|---|
| Length of the strip’s cable | 270 mm |
| Maximum power | 12 W |
| Voltage | 24 V |
| Maximum intensity | 0.50 A |
| Connector | DC male 5.5 x 2.1mm |
| Battery-powered remote control | CR2025 |
| Remote communication | Infrared |
| Operating temperature | 0-40 °C |
- www.alveo3d.com
- Technical support atcontact@alveo3d.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>