MaxMate SS2N35208MX 3.5 Inch Oval Nerf Bar Side Steps Installation Guide
- June 1, 2024
- MaxMate
Table of Contents
MaxMate SS2N35208MX 3.5 Inch Oval Nerf Bar Side Steps
BEFORE INSTALLATION
BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM THE BOX AND VERIFY ALL PARTS ARE PRESENT. FAILURE TO IDENTIFY DAMAGE BEFORE INSTALLATION COULD LEAD TO A REJECTION OF ANY CLAIM. IF MISSING PARTS OR ANY DAMAGE ARE FOUND, PLEASE TAKE A PHOTO TO FILE A CLAIM. TO FILE YOUR CLAIM, PLEASE EMAIL SUPPORT@MAXMATEDEPOT.COM.
TORQUE VALUES
Parts List
STEP 1
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. CLEAN MOUNTING STUDS WITH WIRE BRUSH TO REMOVE PAINT AND DEBRIS.
STEP 2
Starting on the Passenger/Right side front of the vehicle (Fig1) Attach (1) Passenger/Right Mounting Bracket to the Front Location with (2) 8mm Flat Washers and (2) 8mm Flange Nuts. (Fig 2A)
ATTENTION
Some Frontier models have front factory studs that are too short to fit both
Flat Washers and Flange Nuts. In this case, omit the Flat Washers and only
install the Flange Nuts. (Fig 2B)
STEP 3
Repeat STEP 2 to attach the remaining Passenger/Right Mounting Brackets to the
centre and rear locations (Figs 3 & 4).
STEP 4
Select the Passenger/Right Sidebar. Carefully place the Sidebar on the
brackets.
IMPORTANT: DO NOT slide or rotate the Sidebar on cradles, or damage to
the finish may result. Attach the Sidebar to the Mounting Brackets with (6)
8mm Combo Bolts (Figs 5 & 6). DO NOT tighten hardware at this time.
STEP 5
Level and adjust the Sidebar and tighten all hardware.
STEP 6
Repeat STEPS 1-5 to attach the Driver/Left Sidebar
STEP 7
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>