MaxMate LD3C71018MX Triangular Drop Steps Instruction Manual
- June 2, 2024
- MaxMate
Table of Contents
TRIANGULAR DROP STEP
LD3C71018MX
BEFORE INSTALLATION
BEFORE INSTALLATION READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. FAILURE TO IDENTIFY DAMAGE BEFORE INSTALLATION COULD LEAD TO A REJECTION OF ANY CLAIM. IF MISSING PARTS OR ANY DAMAGE ARE FOUND, PLEASE TAKE A PHOTO FOR THE PURPOSE OF FILING A CLAIM. TO FILE YOUR CLAIM, PLEASE EMAIL SUPPORT@MAXMATEDEPOT.COM.
TORQUE VALUES
| 6mm | 7-Jun | Class 10.9 Torque (ft-lbs) |
|---|---|---|
| 8mm | 15-16 | 125-126 |
| 10mm | 31-32 | 7-Jun |
| 12mm | 54-55 | 22-23 |
| 14mm | 87-88 | 44-45 |
| Fastener Size | Class 8.8 Torque (ft-lbs) | 78-79 |
x1 Driver/Left Drop Step
x1 Passenger/Right Drop Step
x4 Driver/Left Mounting Brackets
x4 Passenger/Right Mounting Brackets
x16 8mm x 30mm Hex Bolts
x16 8mm x 25mm Combo Bolts
x16 8mm Lock Washers
x16 8mm x 24mm OD x 2mm Flat Washers
Part List
PROCEDURE :
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
STEP 1
Start the installation under the Passenger/Right side of the vehicle.
a. For “Early” 2019 models, locate the 6 plugs along the bottom edge of the
body. Mounting Brackets will bolt to the 1st, 3rd, 4th and 6th threaded
mounting holes (Fig 1). Passenger/Right side Installation Pictured
b. For “Late” 2019 models, all (4) mounting locations will be used.
STEP 2
Remove the plastic plugs from the passenger/right front mounting location.
Select (1) Mounting Bracket. Attach the Mounting Bracket to the factory
threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat
Washers (Figs 2 & 3). DO NOT tighten hardware.
STEP 3
Repeat STEPS 1 & 2 to attach (3) Mounting Brackets to the (3) remaining
locations along the rocker panel (Figs 4-7). DO NOT tighten hardware.
Passenger/Right side Installation Pictured
STEP 4
Select the Passenger/Right Drop Step. Attach the Drop Step to the (4) Mounting
Brackets with (8) 8mm Combo Bolts (Fig 8). DO NOT tighten hardware.
Passenger/Right side Installation Pictured
STEP 5
Level and adjust the Drop Step, then fully tighten all hardware.
STEP 6
Repeat STEPS 1-5 to attach the Driver/Left Drop Step.
STEP 7
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
contact us:support@maxmatedepot.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>