MaxMate SS2C35068MX 3.5 Step Bars Installation Guide
- June 2, 2024
- MaxMate
Table of Contents
MaxMate SS2C35068MX 3.5 Step Bars
BEFORE INSTALLATION
BEFORE INSTALLATION READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. FAILURE TO IDENTIFY DAMAGE BEFORE INSTALLATION COULD LEAD TO A REJECTION OF ANY CLAIM. IF MISSING PARTS OR ANY DAMAGE ARE FOUND, PLEASE TAKE A PHOTO FOR THE PURPOSE OF FILING A CLAIM. TO FILE YOUR CLAIM, PLEASE EMAIL SUPPORT@MAXMATEDEPOT.COM.
TORQUE VALUES
| Fastener Size | Class 8.8 Torque (ft-lbs) | Class 10.9 Torque (ft-lbs) |
|---|---|---|
| 6mm | 6-7 | 6-7 |
| 8mm | 15-16 | 22-23 |
| 10mm | 31-32 | 44-45 |
| 12mm | 54-55 | 78-79 |
| 14mm | 87-88 | 125-126 |
Parts List
Bottom View
NOTE : REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
STEP 1: Start the installation under the passenger/right side of the
vehicle. Locate the 6 plugs along the bottom edge of the body. Mounting
Brackets will attach to the 1st, 3rd, 4th and 6th threaded mounting holes,
(Fig 1). Remove the plastic plugs from each mounting location. Directly above
each threaded insert is a top mounting location on the side of the body panel.
Hold a Bracket up in place to help determine the mounting holes to use along
the body.
NOTE : Thread an 8mm Hex Bolt into the threaded inserts to clear paint as
required.
STEP 2:
Select (1) Mounting Bracket. Starting at the passenger/right side front of the
vehicle, attach the Mounting Bracket to the factory threaded holes with (2)
8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figs 2-3). DO
NOT tighten hardware at this time.
STEP 3: Repeat STEPS 1-2 to attach the (3) Mounting Brackets to the remaining passenger/right side mounting locations along the body panel.
STEP 4:
Select the passenger/right Sidebar .Use the illustration above to help
determine the correct Sidebar.
NOTE : The rear step pad is closer to the end of the Sidebar. Place the
Sidebar on top of the Brackets.
IMPORTANT : DO NOT slide, (front to back or rotate), the Sidebar on the
Brackets or damage to the finish may result.
STEP 5: Attach the Sidebar (8) 8mm Combo Bolts, (Figs 5-9). 
STEP 6: Level and adjust the Sidebar and fully tighten all hardware.
STEP 7 : Repeat STEPS 1-6 to install the Driver/Left Sidebar D.
STEP 8: Do periodic inspections to the installation to make sure that all
hardware is secure and tight.
Contact us:support@maxmatedepot.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>