CONNEX COX790128 Tile Cutter User Manual
- June 1, 2024
- Connex
Table of Contents
CONNEX COX790128 Tile Cutter
Model designation : COX790128
Dimensions : 550 x 145 x 125 mm
Operating manual
| Number | Description | Quantity |
|---|---|---|
| 1 | Cutting wheel bracket | 1 |
| 2 | Lever | 1 |
| 3 | Breaking device | 1 |
| 4 | Lever handle | 1 |
| 5 | Support part | 2 |
| 6 | Rubberised corner caps | 4 |
| 7 | Base plate | 1 |
| 8 | Guide tubes | 2 |
| 9 | EVA padding | 2 |
| 10 | Guide device | 1 |
| 11 | Mechanical stop | 1 |
| 12 | Stop bracket | 1 |
Please keep these instructions and read them carefully before using the tile cutting machine.
Safety instructions
- Keep away from children.
- The tile cutting machine is fitted with a replaceable cutting wheel. Check the cutting wheel‘s backlash and turnability before use and correct if necessary.
- Clean the machine after use and store in a safe, dry place.
- Not suitable for natural stone tiles and/or heavily structured tiles.
- Place the machine on a level, clean and solid surface before use.
- Caution: Cut/broken tiles have sharp edges.
- Problems can arise with tiles that have been fired multiple times. Ask a specialist (tiler).
Cutting and breaking tiles
- Mark the break line with pencil/permanent marker.
- Push the tile against the mechanical stop, the glazed side must face upwards.
- Position the cutting wheel at the beginning of the line marked.
- Press the cutting lever/cutting wheel downwards, onto the tile, pushing forward along the marking. Make sure that there is a uniform grinding noise. Repeat the process if necessary.
- Position the breaking device at the front on the tile and press the handle downwards carefully.
IMPORTANT : The cutting wheel must not touch the tile!
Maximum and minimum thickness of the material to be cut; max. cutting length depending on tiles’ material characteristics.
Care
Clean the machine carefully after use. Allow the machine to dry completely
after use. Lubricate the guide tubes (household oil, COX591100) after each
cleaning/use.
Changing the cutting wheel
Replace the cutting wheel with an original replacement part from the manufacturer only. Unscrew the nut of the cutting wheel bracket‘s axle and remove the axle. Replace the cutting wheel, insert and tighten the axle. The cutting wheel must run smoothly and must have just a little backlash. Lubricate slightly.
Disposal
Defective machines that cannot be repaired must be sent for disposal of
recyclable material.
Conmetall Meister GmbH
Hafenstraße 26
29223 Celle · GERMANY
www.conmetallmeister.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>