cecotec CCTC-05519 Fast and Furious Iron Instruction Manual

cecotec CCTC-05519 Fast and Furious Iron

SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance. Keep this instruction manual for future reference or new users.

• All safety instructions should be closely followed when using the appliance.
• Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded.
• If the cord is damaged, it must be replaced by the official Technical Support Service of Cecotec in order to avoid any type of danger.
• Do not immerse the cord, plug, or any non-removable part of the appliance in water or any other liquid, nor expose the electrical connections to water. Make sure your hands are dry before handling the plug or switching on the appliance. If the appliance falls accidentally in water, unplug it immediately. Do not reach into the water! Do not twist, bend, strain, or damage the power cord in any way. Protect it from sharp edges and heat sources. Do not let it touch hot surfaces. Do not let the cord hang over the edge of the surface.
• Never hold the steam head down while at rest or tilt it in a backward position as this may result in hot water discharge and possibly injury.
• This appliance is not intended to be operated by means of an external timer or separate remote-control system.
• Turn off and unplug the appliance from the mains supply when not in use and before cleaning it. Pull from the plug, not the cord, to disconnect it from the outlet.
• This appliance is designed to iron textiles. It is designed for domestic use only and, therefore, not suitable for commercial use. Do not use outdoors.
• To protect against burns or injuries to persons, do not iron textiles while being worn on the body.
• Use care when turning the device upside down; there may be hot water in the tank. Avoid rapid movement of the device to minimize hot water spillage.
• Place the appliance on a dry, stable, flat, heat-resistant surface.
• The temperature of accessible surfaces may be high while in use and could cause burns. Do not touch hot surfaces while in use or immediately after.
• Do not aim steam at people or animals and do not iron clothes directly on the body to avoid risk of burns.
• Do not leave the product unsupervised during operation.
• Unplug the device after use and when you leave the room where it is installed.
• Do not use the device when the water tank is empty.
• Do not allow the power cord to come into contact with high-temperature steam during product operation.
• To protect against burns or injuries, do not direct steam toward persons or animals when ironing.
• Do not use the device with perfume, vinegar or other liquids.
• This product is designed to operate only with water.
• Do not try to repair the device by yourself. Contact the official Technical Support Service of Cecotec for advice.
• Cleaning and maintenance must be carried out according to this instruction manual to make sure the appliance functions properly. Turn off and unplug the appliance before moving, cleaning it, or assembling or disassembling any of its parts.
• Make sure the device has completely cooled down before storing it.
• It is not recommended to use the device on leather, suede, vinyl, or other steam-sensitive fabrics.
• Cleaning and maintenance tasks must not be carried out by children.
• Store the appliance and its instruction manual in a safe and dry place when not in use.
• Cecotec takes no responsibility for any damage caused by misuse of the appliance. Any misuse or non-compliance with these instructions renders the warranty and Cecotec’s liability null and void.
• The appliance is not intended to be used by children under the age of 8. It can be used by children over the age of 8, as long as they are given continuous supervision.
• This product can be used by children and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance. Close supervision is necessary when the appliance is being used by or near children.
• Keep this appliance and its power cord out of reach of children under the age of 8.

Warning: All our ironing range’s products have undergone quality control tests previous to their commercialization. These tests consist of filling the water tank in order to check the tightness and to ensure the correct operating of the device. Once the test has been carried out, the tank is emptied and dried, but there is a slight probability that water could remain inside it.

PARTS AND COMPONENTS

1. Plate
2. Continuous steam slide button
3. Steam trigger
4. Handle
5. Water tank button
6. Removable water tank
7. Power/steam level light indicator
8. Power/steam power level button
9. Brush attachment

BEFORE USE

• Take the product out of the box.
• Make sure all the accessories are included and check for any visible damage. If any is observed, contact the Technical Support Service of Cecotec.
• Remove any packaging materials, stickers or protective foil attached to the main body or the cord.
• To reduce the risk of burns and damage, check the appliance before each use by holding it away from body and operating the steam button.
  Note: Using distilled, purified or filtered water is highly recommended to maintain optimal performance. Tap water contains minerals that build up over time

OPERATION

Note: It is normal to feel or hear the water pump in the handle. This feeling or noise could become more louder or more noticeable when the water tank is empty.

• Connect the appliance to the power supply.
• Press the power/steam power level button to turn the device on. The light indicator will flash, and the device will start preheating. Then, the light indicator will turn steady on indicating the preheating process is over and the device is ready to use. The preheating process will take about 35 seconds.
• Press the power/steam power level button again, 2 of the steam power level indicator grids will light up, indicating the medium steam power level is activated.
• Press the power/steam power level button again, 3 of the steam power level indicator grids will light up, indicating the high steam power level is activated.
• Press the power/steam power level button whenever you wish to switch between the 3 steam power levels.
• Hold down the power/steam power level button to turn the device off.

Brush attachment

This attachment can be used in garments that require medium-high heat and are steam proof. This attachment can be useful to remove lint, hair, and pet hair from garments.

While the device and the attachment are cool, gently attach the top of the brush over the top the garment steamer head and then click the bottom of the brush into place. (A) To remove the brush attachment, gently pull on the tab. (B)
Warning: Be careful when removing the brush attachment as condensation may build up during use.

Filling the water tank

• Place the device on its base on a stable surface.

• Hold the device from the handle with one hand and pull out the removable water tank with the other hand. (C)

• Gently open the tank cover at the front of the tank. (D)
  Note: Using distilled, purified, or filtered water is highly recommended and will reduce mineral buildup. Do not use oils, perfumes or scented additives.

• Using a clean measuring cup, pour water into the opening until water reaches the “MAX” level mark on the top of the tank. (E)

• Do not overfill. Close the rubber cover securely.

• Dry off any excess water from the tank. Push the water tank back into the garment steamer base until it clicks into place.

• To refill at any time during use, turn the garment steamer off by pressing the power/steam power level button until the indicator light turns off, unplug from the power outlet, and follow the above procedure.

• After refilling the tank, allow the device to preheat for 45 seconds and then press the steam trigger until steam is produced.

Continuous steam function

• Connect the appliance to the power supply.
• Press the power/steam power level button to turn the device on. The light indicator will flash and the device will start preheating. Then, the light indicator will turn steady on indicating the preheating process is over and the device is ready to use. The preheating process will take about 35 seconds. (F).
• Press on the steam trigger until steam is produced to check the device has preheated correctly.
• To generate steam, press down on the steam trigger with your index finger. (G)
• As long as the trigger is held down, steam will emit from the garment steamer. To stop the continuous steam function, release the trigger.
• To generate a constant flow of steam without holding the trigger, press the steam trigger and then slide the continuous steam slide button down. (H)
• To turn the continuous steam function off, press the trigger, slide the continuous steam slide button up and then release the trigger.

When ironing using a heatproof vertical pad or surface, start steaming and then lightly press the metal plate against the garment on the ironing pad or surface. (M) Drag the plate up and down the fabric, being careful to keep hands away from the steam and never leaving the plate in one section for too long. Use it similarly to how an iron is used.

Safety system
This device features a safety system that avoids incidents from occurring as the iron is disconnected in case of overheating.

Steam cleaning at home
The device can also be used to clean household items resistant to heat. Damp steam cleaning is not harmful or toxic, plus it is inexpensive. This natural cleaning method is beneficial to those sensitive to chemical cleaners or trying to reduce chemicals at home. It can be used to steam upholstery, draperies, linens and home textiles for a complete cleaning

Tips
Always test garments by steaming a small hidden area to make sure the garment operates properly and is ready to use. Always read garment care label instructions before ironing or steaming clothes and other garments. Small amounts of dripping might occur during use. If excessive, the garment steamer may need time to get back up to full temperature. Allow the garment steamer to reheat. Wearing clothes immediately after ironing or steaming can actually create creases. Always allow clothing to cool for about 5 minutes after ironing or steaming before wearing it.

CLEANING AND MAINTENANCE

When you have finished using the device, ensure it is thoroughly dried. Turn it back on and lightly steam over an old cloth. This will help remove any residue left in the steam holes. When finished cleaning, turn the garment steamer off by pressing the power button until the power light turns off (about 2 seconds).

• Unplug the appliance from the power supply, empty the water tanks (do it after each use) and allow it to cool down completely.
• Use a soft, damp cloth to clean the device’s surface after each use.
• Do not use abrasive cleaners or scouring pads to clean the product.
• If scale blocks the steam holes, use a toothpick to remove it.
• If the appliance is not going to be used for a long time, pour out the water in the tank and store the iron in a safe, cool place.
• Always store the garment steamer in an upright position on its base to prevent water leakage.

Cleaning the brush attachment Allow to fully dry before using again or storing. Clean the brush with a damp cloth.

TROUBLESHOOTING

TECHNICAL SPECIFICATIONS

• Product: Fast&Furious 4050 X-Treme
• Product reference: 05519 220 V- 240 V; 50 -60 Hz 1650-1960 W

DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE), specifies that old household electrical appliances must not be disposed of with the normal unsorted municipal waste. Old appliances must be collected separately, in order to optimize the recovery and recycling of the materials they contain and reduce the impact on human health and the environment. The crossed-out “wheeled bin” symbol on the product reminds you of your obligation to dispose of the appliance correctly. If the product has a built-in battery or uses batteries, they should be removed from the appliance and disposed of appropriately. Consumers must contact their local authorities or retailer for information concerning the correct disposal of old appliances and/or their batteries..

TECHNICAL SUPPORT AND WARRANTY

This product is under warranty for 2 years from the date of purchase, as long as the proof of purchase is submitted, the product is in perfect physical condition, and it has been given proper use, as explained in this instruction manual. The warranty will not cover the following situations:

The product has been used for purposes other than those intended for it, misused, beaten, exposed to moisture, immersed in liquid or corrosive substances, as well as any other fault attributable to the customer. The product has been disassembled, modified, or repaired by persons, not authorised by the official Technical Support Service of Cecotec. Faults deriving from the normal wear and tear of its parts, due to use. The warranty service covers every manufacturing defects of your appliance for 2 years, based on current legislation, except consumable parts. In the event of misuse, the warranty will not apply.
If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728.

References

• SmartGroup

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>