Ardes AR5ST40PNR Steelo 40pnr Floor Fan Instruction Manual
- June 1, 2024
- Ardes
Table of Contents
Ardes AR5ST40PNR Steelo 40pnr Floor Fan
WARNINGS
This appliance may be used by children 8 years of age and older and people
with reduced physical, sensory or mental capacities or with a lack of
experience and knowledge if they are adequately supervised or have been
instructed on the safe use of the appliance and are aware of the related
dangers.
Children must not play with the appliance. leaning and maintenance must not be
performed by children unless they are under supervision.
Cleaning and maintenance operations must not be performed by children without
supervision.
If the power cable gets damaged, it has to be replaced only at a service
centre approved by the manufacturer in order to prevent any risks.
Ensure that the fan is switched off from the supply mains before removing the
guard.
Don’t connect the appliance to the power supply and don’t use it unless it is completely assembled (see mounting instructions).
ATTENTION : read this booklet carefully it contains important
instructions for a safe installation, use and maintenance.
Important instructions to be kept for future reference.
It is forbidden for the children to play with the device.
This device must be used only for the purpose it was expressly designed; any
use not complying with the instructions contained in the manual is considered
inappropriate and dangerous. The manufacturer is not responsible for possible
damages caused by the inappropriate and/or unreasonable use.
This device is NOT suitable to use it in an explosive environment (in the
presence of flammable substances such as gas, vapor, mist or dust, in
atmospheric conditions when, after ignition, the combustion is spread in the
air).
The packing materials (plastic bags, expanded polystyrene, etc.) must be kept
out of the reach of children or disabled persons since they represent
potential sources of danger.
The installation/assembly of the device will be made/ or according to the
indications of the manufacturer. A wrong procedure may cause damages to
persons, animals or objects, for which the manufacturer cannot be considered
responsible.
Place and use the device on a horizontal and stable surface.
Before use check the integrity of the device and power cable. In case you are
not sure contact a qualified person.
Before powering the device make sure the rating (voltage and frequency)
corresponds to the grid and the socket is suitable for the plug of the device.
Make sure the power system is equipped with proper protection according to the
law in force.
DO NOT power the device using multiple sockets.
If possible, avoid the use of adapters and/or extension cables; if their use
is absolutely necessary, use only materials in compliance with the current
safety regulations and according to the electrical parameters of the adapters.
The device must not be switched on using external timers and/or other remote
control devices which are not specified in this manual.
DO NOT use or store the device near heat sources (heaters, stoves etc.).
DO NOT dip the device in water or other liquids; in case the accidental
fall in the water DO NOT try to take it out, but first of all unplug
immediately the power cable from the socket.
If you use the device for the first time, make sure to remove any label or
protective sheet which blocks its proper functioning.
Plug and unplug the power cable with dry hands and hold it firmly.
Before plugging make sure the start button of the device is in the “OFF”
position (turned off).
Always unplug the power cable to avoid the overheating and avoid stretching it
(do not pull it, tug it or use it to drag the device to which is connected).
Avoid placing the power cable on abrasive or sharp surfaces or in positions
where it can be damaged easily.
DO NOT obstruct totally nor partially the air vents or inserts objects
inside.
During the functioning do not touch the device with wet body parts, and in any
case it is recommended to have between you and the standing surface, an
isolating element (for ex. wearing shoes with rubber soles).
During the use the device must be keep at a safety distance from any object
and/or flammable or potentially explosive substance.
In case of malfunction or anomalies during the functioning, switch off the
device immediately, turn off the power and check the cause of the anomalies,
if possible, with the support of a qualified person. Avoid carrying out
operations which are not specified in this manual (such as disassembling
and/or altering).
Always remember to unplug the power cable of the device if it is not used for
a long period, before storing, cleaning or performing any maintenance
operation.
Store and use the device only indoor or in any case protected from weathering
such as rain, direct radiation of the sun and dust. The device is not design
for the external use or storage.
The cleaning and maintenance of the device MUST NOT be done by children
without the supervision of an adult.
Before unplugging the device, switch it off, using the proper command on the
control panel.
DO NOT hang the fan on the wall or ceiling unless this type of
installation is provided and explained in this manual.
Place the device at a proper distance from the objects or surrounding walls
making sure that its functioning will not cause accidental damages.
DO NOT use the device near gas stoves or open flames in general.
DO NOT use the device near curtains or textiles.
DO NOT hang the fan on the wall or ceiling unless this type of
installation is provided and explained in this manual.
DO NOT cover the device during functioning.
DO NOT insert objects or body parts inside the protection grille of the
fan.
DO NOT leave the device unsupervised for a long period during
functioning.
DO NOT expose yourself for a long period to the air flow generated
by the device because it can cause damage to the health.
If the fan must be stored for a long period and is not used regularly, place
the fan in its original packaging in a dry place. When you use it for the
first time after a long period of inactivity, make sure the fan is clean and
the motor blades turn feely (with the device not powered) without any
restraint.
WARNINGS ABOUT BATTERIES
-
KEEP BATTERIES OUT OF THE REACH OF CHILDREN.
Swallowing can lead to chemical burns, perforation of soft tissue, and death. Severe burns can occur within 2 hours of ingestion. Seek medical attention immediately. -
Do not allow children to replace batteries.
-
Always insert batteries correctly with regard to polarity (+ and -) marked on the battery and the equipment.
-
Do not short-circuit batteries.
-
Do not charge batteries.
-
Do not force discharge batteries.
-
Do not mix new and used batteries or batteries of different types or brands.
-
Exhausted batteries should be immediately removed from equipment and properly disposed of.
-
Do not heat batteries
-
Do not weld or solder directly to batteries.
-
Do not dismantle batteries.
-
Do not deform batteries.
-
Do not dispose of batteries in fire.
-
Do not expose batteries to water or humidity, especially in case their container were damaged.
-
Do not encapsulate and/or modify batteries.
-
Store unused batteries in their original packaging away from metal objects. If already unpacked, do not mix or jumble batteries.
-
Remove batteries from equipment if it is not to be used for an extended period of time unless it is for emergency purposes.
-
Clean the battery contacts and also those of the equipment prior to battery installation.
-
In case of leak from batteries, avoid any contact with it; in case of contact, wash the affected part with water and seek medical attention.
ASSEMBLING
- Front grille
- Lock ring of the fan
- Safety screw of the fan
- Fan
- Lock ring of the back grille
- Back grille
- Motor shaft
- Motor
- Control panel
- Main body screw
- Adjustment rod
- Height adjustment knob
- Base rod
- Feet (4 pieces)
- Bracket
A-B. Locking pin for the rear grille
INSTRUCTIONS FOR USE
Place the fan on a flat, dry and stable surface, and insert the plug of the
fan in a socket; the unit will emit a short “BIP” sound indicating that power
is supplied.
For your convenience the unit can be operated by using control panel in the
main body or using remote control included.
-
Control panel
-
Remote control
Buttons
A. POWER – ON/OFF
B. SPEED
C. MODE
D. TIMER
E. OSC (only from remote control)
Indicator light
X. indicator light of speeds
Y. indicator light of timer
Z. indicator light of mode
W. indicator light of oscillation
Batteries
Remote control is supplied without batteries; before use remote control open
the batteries holder placed on the back of remote control (refer to the
diagram shown on the back of the remote control) and insert 1 battery CR2025
3V respecting the indicated polarity. To remove the battery, refer to the
diagram shown on the back of the remote control.
POWER – ON/OFF Button (A):
Press Power – On/Off button one time to activate the fan. The unit will start
to operate at lower speed.
Press Power – On/Off button when unit is on to turn it off.
SPEED Button (B):
Press this button when unit is on to select the desired speed. The related indicator light of speed (X) will turn on in the control panel: “L” low speed, “M” medium speed or “H” high speed.
MODE Button (C):
Press this button when unit is on to select the desired mode: normal, natural mode (the indicator light “NA” will turn on in the control panel) or sleeping mode (the indicator light “SL” will turn on in the control panel).
TIMER Button (D):
When the unit is operating, you can set the timer to switch the fan off
automatically after the set time. Press this button repeatedly to select the
desired time period in half hours increments from 0,5 hours to 7,5 hours.
The related indicator light of timer (0,5H, 1H, 2H, 4H) will illuminate on the
control panel. When all the indicators light are off means that timer is not
setted and the unit will continuously work until you switch off manually the
unit.
OSC Button (E):
Press this button when unit is on to activate the automatic oscillation from left to right (the “OSC” indicator light will turn on in the control panel). To deactivate the automatic oscillation press again this button.
VERTICAL SLOPE:
You can vertically point the front of the fan choosing the desired angle. It is sufficient to move the front of the fan up or down according to the desired slope.
ADJUSTMENT HEIGHT.
Loosen the height adjustment knob (12), then set the desired height for the
fan. Tighten firmly the knob after adjusting the rod.
N.B: this operation must always be carried out while the fan is turned off.
MAINTENANCE
Before carrying out the regular cleaning operations turn off the fan and
unplug it.
Ensure that the fan is switched off from the supply mains before removing the
guard.
For external cleaning use a soft and dry cloth.
DO NOT dip the device in water, or splash it with any other liquids.
DO NOT use solvents or any other chemical products for cleaning it.
Reinstall the guard after cleaning and before connecting the plug tot he
mains.
When you do not use it, after cleaning it, store the fan in a dry place.
USER INFORMATION
PACKAGING
In order to respect the environment, packaging material must be disposed of
properly in accordance with separate collection.
Check local regulations.
BATTERIES – Remove the batteries from the appliance before its disposal.
Do not dispose the batteries with domestic waste. The batteries must be
disposed of in the appropriate containers or in the specific collecting
centre. Suitable segregated collection helps prevent damage to the environment
and to human health.
To remove batteries, refer to Instructions for use.
USER INFORMATION
“Implementation of Directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE)”, pertaining to reduced use of hazardous substances in
electrical and electronic equipment, as well as to waste disposal.
The symbol of the crossed-out wheelie bin on the equipment or on its packaging
indicates that the product must be disposed of separately from other waste at
the end of its service life.
The user must therefore take the dismissed equipment to suitable separate
collection centres for electrical and electronic waste.
For more details, please contact the appropriate local authority.
Suitable segregated collection of the equipment for subsequent recycling,
treatment or environmentally friendly disposal helps prevent damage to the
environment and to human health, and encourages the re-use and/or recycling of
the materials that make up the equipment.
Abusive disposal of the product by the user shall result in the application of
administrative fines in accordance with the laws in force.
GUARANTEE
Terms and Conditions
The guarantee is valid for 24 months.
This guarantee applies only if it has been duly filled in and is submitted
with the receipt showing the date of purchase.
The guarantee covers the replacement or repair of parts making up the
appliance which were faulty at source due to manufacturing faults.
After the guarantee has expired, the appliance will be repaired against
payment.
The manufacturer declines any responsibility for damage to persons, animals or
property due to misuse of the appliance and failure to observe the directions
contained in the instructions.
Limits
All rights under this guarantee and any responsibility on our part will be voided if the appliance has been:
- mishandled by unauthorized persons
- improperly used, stored or transported.
The guarantee does not cover damage to the outward appearance or any other that does not prevent regular operation.
If any faults should be found despite the care taken in selecting the materials and in creating the product, or if any information or advice are required, please contact your local dealer.
CUSTOMER SUPPORT
Poly Pool S.p.A. Via Sottocorna, 21/B
24020 Parre (Bergamo) – Italy Tel. +39 035 4104000 r.a. – Fax +39 035
702716
http://www.ardes.it – e-mail:
polypool@polypool.it
MADE IN CHINA 
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>