Ardes AR4C03T Fan Convector Heater Instruction Manual
- June 3, 2024
- Ardes
Table of Contents
AR4C03/AR4C03T – Fan Convector Heater
Instruction Manual
AR4C03T Fan Convector Heater
This product is only suitable for well insulated spaces or occasional use.
This appliance can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience
and knowledge if they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance
shall not be made by children without supervision. Children of less than 3
years should be kept away unless continuously supervised. Children aged from 3
years and less than 8 years shall only switch on/off the appliance provided
that it has been placed or installed in its intended normal operating position
and they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children aged
from 3 years and less than 8 years shall not plug in, regulate and clean the
appliance or perform user maintenance.
CAUTION — Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
If the power cable gets damaged, it has to be replaced only at a service
centre approved by the manufacturer.
DO NOT COVER
WARNING: In order to avoid overheating, do not cover the heater.
Do not place the appliance immediately below a socket outlet.
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
Don’t connect the appliance to the power supply and don’t use it unless it is
completely assembled (see mounting instructions).
In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by
the utility.
Warnings
ATTENTION : read this booklet carefully it contains important instructions
for a safe installation, use and maintenance.
Important instructions to be kept for future reference.
-
Keep handy the guarantee, receipt of payment and these instructions for future use and reference.
-
After removing the packaging, check the appliance for any signs of damage.
-
In case of visible damage, do not use it and contact a qualified technician. Do not leave parts of the packaging with in the reach of children.This appliance is not a children’s toy: it is an electrical device and must be treated with the necessary caution.
-
Before connecting the appliance, make sure that the power supply voltage matches the indication on the data plate.
-
If the plug and socket are not compatible, the socket has to be replaced with a suitable type by skilled persons.
-
Do not use adapters or extension cables which do not meet current safety standards or that exceed the current carrying capacity limits.
-
When you don’t use the appliance disconnect it from the power supply and assure that the interruptor is off.
-
Do not tug on the power cable or on the appliance itself to remove the plug from the socket.
-
The use of any electrical appliance requires that a number of basic rules are observed, namely:
– Never touch the appliance with wet or humid hands.
– Do not leave the appliance exposed to weathering (rain, sunlight).
– Do not subject it to rough handling. -
In case of a breakdown or malfunctioning of the appliance, disconnect it at once.
-
Do not attempt to repair it, but take it to a service centre approved by the manufacturer.
-
If you decide you do not want to use this appliance any longer, disable it by cutting the power cable – of course, after disconnecting it from the socket.
-
The power cable should be extended to its full lenght to avoid overheating.
-
For safety reasons, the appliance should never be opened.
-
The appliance has been designed and manufactured to operate in the home.
-
Any other use is considered inappropriate and dangerous.
-
Do not insert objects through the safety grill or the air inlets.
-
During use, rest the appliance on a flat surface.
-
Do not use this heating appliance with programmers, timers, separate remote control systems (different to the ones provided with the appliance) or any other device that automatically turns on the appliance, as there is a risk of fire in the event the appliance is covered or positioned incorrectly.
-
Do not use the heater in presence of flammable substances (petrol,paints, etc.).
-
Do not place the cord near sources of heat.
WARNING: DO NOT COVER THIS PRODUCT NEAR CURTAINS OR OTHER COMBUSTIBLE
MATERIAL.
WARNING: DO NOT COVER THE APPLIANCE OR OBSTRUCT THE AIR INLETS TO AVOID
OVERHEATING.
Technical informations
- Handle
- Function switches
- Adjustable thermostat
- Timer (provided on item 4C03T only)
- Supports
Technical data indicated on the appliance.
Instructions for use
SUPPORT ASSEMBLY
Turn the appliance over, rest the plastic supports in place matching the holes
with those on the appliance. Then fix the supports with the 2 3.8x14mm screws.
The appliance can emit both cool air as well as hot air, depending on the
appliance setting.
Before connecting or disconnecting the appliance, make sure that all the
switches are in the OFF position.
To turn the appliance on, insert the plug in the power outlet, set the
operation switch in the desired position and turn the temperature switch (3)
clockwise to the maximum position.
Once the desired room temperature is reached, turn the handle slowly, in a
counter clockwise direction, until the appliance is turned off.
At this point, the product will automatically restart when the temperature in
the room goes below the set limit.
The appliance is also equipped with a daily timer that allows the user to set
the automatic turn-on and turn-off of the appliance.
Before replacing the appliance in its package, make sure it has cooled
sufficiently.
OPERATION WITH TIMER (AR4C03T only)
To operate the appliance continually, position the TIMER switch (1) on “I”,
while for programmed operation it has to be positioned on “CLOCK”. The TIMER
works only if the plug is inserted in the power outlet.
To program the appliance, position the arrow (2) on the current time and
select the teeth (3) (pushing them outwards) corresponding to the period in
which you want the appliance to operate.
Make sure that the appliance has cooled down completely before storing it in
the box.
Maintenance
This appliance does not require any special maintenance.
Disconnect the plug from the socket and let the appliance cool down well
before cleaning it.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from
entering into the apparatus and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Information requirements for electric local space heaters
| Model identifier(s): | AR4C03 |
|---|---|
| Item | Symbol |
| Heat output | **Type of heat input, for electric storage local space |
heaters only (select one)
Nominal heat output| Pnom| 1,8| kW| Manual heat charge control, with
integrated thermostat| No
Minimum heat output (indicative)| Pmin| 0,7| kW| Manual heat charge control
with room and/or outdoor temperature feedback| No
Maximum continuous heat output| Pmax,c| 1,8| kW| Electronic heat charge
control with room and/or outdoor temperature feedback| No
Auxiliary electricity consumption| Fan assisted heat output| No
At nominal heat output| elmax| N.A.| kW| Type of heat output/room
temperature control (select one)
At minimum heat output| elmin| N.A.| kW| Single stage heat output and no room
temperature control| No
In standby mode| elSB| N.A.| kW| Two or more manual stages, no room
temperature control| No
| | | | With mechanic thermostat room temperature control| Yes
| | | | With electronic room temperature control| No
| | | | Electronic room temperature control plus day timer| No
| | | | Electronic room temperature control plus week timer| No
| | | | Other control options (multiple selections possible)
| | | | Room temperature control, with presence detection| No
| | | | Room temperature control, with open window detection| No
| | | | With distance control option| No
| | | | With adaptive start control| No
| | | | With working time limitation| No
| | | | With black bulb sensor| No
Contact details| POLY POOL S.p.A. – via Sottocorno 21/B, 24020 Parre (BG) –
Italy
Model identifier(s):| AR4C03T
---|---
Item| Symbol| Value| Unit| Item| Unit
Heat output| Type of heat input, for electric storage local space
heaters only (select one)
Nominal heat output| Pnom| 1,8| kW| Manual heat charge control, with
integrated thermostat| No
Minimum heat output (indicative)| Pmin| 0,7| kW| Manual heat charge control
with room and/or outdoor temperature feedback| No
Maximum continuous heat output| Pmax,c| 1,8| kW| Electronic heat charge
control with room and/or outdoor temperature feedback| No
Auxiliary electricity consumption| Fan assisted heat output| No
At nominal heat output| elmax| N.A.| kW| Type of heat output/room
temperature control (select one)
At minimum heat output| elmin| N.A.| kW| Single stage heat output and no room
temperature control| No
In standby mode| elSB| 0,00025| kW| Two or more manual stages, no room
temperature control| No
| | | | With mechanic thermostat room temperature control| Yes
| | | | With electronic room temperature control| No
| | | | Electronic room temperature control plus day timer| No
| | | | Electronic room temperature control plus week timer| No
| | | | Other control options (multiple selections possible)**
| | | | Room temperature control, with presence detection| No
| | | | Room temperature control, with open window detection| No
| | | | With distance control option| No
| | | | With adaptive start control| No
| | | | With working time limitation| Yes
| | | | With black bulb sensor| No
Contact details| POLY POOL S.p.A. – via Sottocorno 21/B, 24020 Parre (BG) –
Italy
GUARANTEE
Terms and Conditions
The guarantee is valid for 24 months.
This guarantee applies only if it has been duly filled in and is submitted
with the receipt showing the date of purchase.
The guarantee covers the replacement or repair of parts making up the
appliance which were faulty at source due to manufacturing faults.
After the guarantee has expired, the appliance will be repaired against
payment.
The manufacturer declines any responsibility for damage to persons, animals or
property due to misuse of the appliance and failure to observe the directions
contained in the instructions.
Limits
All rights under this guarantee and any responsibility on our part will be
voided if the appliance has been:
- mishandled by unauthorized persons
- improperly used, stored or transported.
The guarantee does not cover damage to the outward appearance or any other
that does not prevent regular operation.
If any faults should be found despite the care taken in selecting the
materials and in creating the product, or if any information or advice are
required, please contact your local dealer.
USER INFORMATION
“Implementation of Directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE)”, pertaining to reduced use of hazardous substances in
electrical and electronic equipment, as well as to waste disposal”.
The symbol of the crossed-out wheelie bin on the equipment or on its packaging
indicates that the product must be disposed of separately from other waste at
the end of its service life.
The user must therefore take the dismissed equipment to suitable separate
collection centres for electrical and electronic waste, or return it to the
dealer in case they purchase a new device of equivalent type, at a one-to-one-
ratio.
Suitable segregated collection of the equipment for subsequent recycling,
treatment or environmentally-friendly disposal helps prevent damage to the
environment and to human health, and encourages the re-use and/or recycling of
the materials that make up the equipment.
Abusive disposal of the product by the user shall result in the application of
administrative fines in accordance with the laws in force.
Poly Pool S.p.A. Via Sottocorno, 21/B
24020 Parre (Bergamo) – Italy
Tel. +39 035 4104000 r.a.
Fax +39 035 702716
http://www.ardes.it
E-mail: [email protected]
MADE IN CHINA
4C03_4C03T.080319