SUPERATV IN-TSK-H-TAL-007 Honda Talon Deluxe Self Canceling Turn Signal Kit Instruction Manual
- June 1, 2024
- SUPERATV
Table of Contents
SUPERATV IN-TSK-H-TAL-007 Honda Talon Deluxe Self-Canceling Turn Signal
Kit
INSTALLATION INSTRUCTION
Plug and Play Turn Signal Kit:
- Do not discard packaging until the product has been successfully installed.
- Components may be installed in locations other than where shown. Alway verify the wire harness length.
- While routing, follow factory wiring when possible.
- Use the provided dielctric grease on all connections.
- Always consult labels on Harnesses when making connections.
- Avoid rotating or hot components when securing.
- Before drilling any holes, check behind the area to be drilled for any interference.
Read instructions and view illustrations before beginning. Thank You
Horn and ECU:
- User may install Horn and ECU in locations different than shown.
- Illustration is SuperATV’s choice.
- Connect Harnesses to Horn and ECU.
- Secure all Wires as needed.
Switch Mounting:
- User may install Switches in locations difffferent than shown.
- Connect Switches to Harnesses and secure. SuperATV recommends testing Switches before permanently mounting.
LED Signals
- User may install in locations different than shown.
- Illustration is SuperATV’s choice.
- Drill a Ø3/4” hole in body and install an LED Signal. Repeat for remaining LED Signals.
- Plug LED Signals into corresponding inputs on the Harness.
- Secure all Wires as needed.
If Light is hard to insert separate as shown.
- Separate LED from Gasket.
- Install Gasket into the hole.
- Install LED into the Gasket.
Reinstall Console and Glovebox.
Rear
- Remove the Rear Cover and disconnect the stock Harness.
- Connect Harness to Stock Harness.
- Secure all Wires as needed.
- Reinstall the Rear Cover.
- If connecting License Plate Light (not included), do so at this time.
CUSTOMER NOTIFICATION AND DISCLAIMER LIABILITY
This product is a modification for utility task vehicles and all-terrain vehicles. Use this product at your own risk.
Warranty and Liability Limitations
The Buyer hereby assumes all risks associated with the use and/or
installation of this product. Buyer waives all liability claims against
SuperATV® of any kind or nature, including, but not limited to, liability for
penalties, fines, property damage, personal injury or death, to the fullest
extent permitted by law. Buyer acknowledges and agrees that SuperATV® is not
liable for any direct, indirect, incidental, consequential or special damages,
including but not limited to, damage, loss of life, loss of property or
equipment, loss of profits or revenue, injury, or claims from any individual
or entity arising from the use of this product. The warranty for this product,
if any, may give you (“Buyer”) specific legal rights, and Buyer may also have
other rights which may vary from state to state. The installation of this
product may void or otherwise adversely affect your factory warranty. Consult
your vehicle warranty before using this Product. Under no circumstances will
SuperATV® be liable for the voidance of the Buyer’s vehicle warranty. Buyer
assumes all risk and responsibility if a manufacturer and/or dealer voids the
Buyer’s vehicle warranty due to the use of this Product.
Safety and Laws.
Operate your vehicle at all times in a safe manner. You must abide by all
local, state, and federal laws, including but not limited to vehicle safety,
traffic laws, and ordinances. It is your responsibility to know the laws and
how they apply to you. The installation of this product may violate certain
local, state, and federal laws. Be advised that laws vary depending on town,
city, county, state, etc. Use of this product on public streets, roads, or
highways may be in violation of law. The Buyer is solely and exclusively
legally and personally responsible for any violation of the law by the
installation or use of this product. In no case will SuperATV® be held liable
if the Buyer violates the law or uses the product in an unsafe manner. The
Buyer is responsible for fully understanding the capability and limitations of
his/her vehicle according to manufacturer specifications, warnings and
instructions and agrees to hold SuperATV® harmless from any damage resulting
from failure to adhere to such specifications, warnings and/ or instructions.
The Buyer is also responsible to obey all applicable federal, state, and local
laws when operating his/her vehicle while using this product, and the Buyer
agrees to hold SuperATV® harmless from any violation thereof.
Installation.
The installation of this product on your vehicle indicates that you have
had the opportunity to inquire about applicable local, state, and federal laws
and ordinances and that you have read understand, and accept all of the terms
of, this Disclaimer. SuperATV® shall not be responsible for the proper
installation, use, and service of this product. Rather, the Buyer shall be
solely responsible for the installation of the product and any damage that may
be done to the vehicle or vehicle components as a result of modifications made
by the Buyer.
Accessory to Turn Signal Kit Wiring
Left Turn Signal Harness shown in illustrations.
Accessory to Turn Signal Kit Wiring continued
SuperATV recommends using a handheld mini torch, or lighter, to activate heat shrink on Connector.
Need help with your installation?
- sales@superatv.com
- 1-855-743-3427
- www.superatv.com
- 8:00am – 8:00pm EST M-Th
- 8:00am – 7:00pm EST Friday
- 9:00am – 2:00pm EST Saturday
Specifications
- Product: Plug and Play Turn Signal Kit for Honda Talon
- Model Numbers: IN-TSK-H-TAL-007 / IN-TSK-H-TALX4-007
- Installation Date: 7/28/2023
- Manufacturer : SuperATV
FAQ
Q: Can I install the components in locations other than those shown in the
manual?
A: Yes, you may install the ECU, Horn, and switches in different locations
as needed. Ensure proper connections and secure all wires.
Q: What should I do if I encounter difficulties during installation?
A: If you encounter any difficulties during installation, contact SuperATV
customer support at sales@superatv.com or call
1-855-743-3427 for assistance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>