VASCO ENY-P1 Electric Post Heating Battery Energy Plus User Guide
- June 1, 2024
- Vasco
Table of Contents
ELECTRIC POST-HEATING
BATTERY ENERGY PLUS
TECHNICAL SPECIFICATIONS ELECTRIC POST-HEATING BATTERY ENERGY PLUS
DESCRIPTION
The electric post-heating battery ensures that the temperature of the supply air can be controlled (heated) by an electric resistance. The resistance operates and is controlled by the temperature of the supply air or the discharge air.
OPERATION
The system switches ON/OFF to achieve the heating setting of the supply air.
The standard setting is 20°C.
The electric post-heating battery can be switched on if the following settings
on the printed circuit board of the Energy Plus ventilation unit are
configured as follows:
- DIP-switch 4 is ON
- DIP-switch 5 is OFF
- DIP-switch 10 is ON: Post-processing controlled by the supply temperature (after the heat exchanger)
- DIP-switch 10 is OFF: Post-processing controlled by the discharge temperature (before the heat exchanger)
If the system is controlled by the supply temperature, it will be necessary to reposition the PT1000 sensor installed on this supply air (T2) (See technical drawing under chapter “Dimensional Drawing and Connections”) to ensure it is positioned after the electric post-heating battery. This PT1000 sensor must be supplied separately.
TECHNICAL SPECIFICATIONS
- To be fitted externally, in the air duct with airflow ‘towards the home’
- Pipe section of high-quality galvanised sheet steel
- ON/OFF 230V control
- Electric control in housing
- Dual safety thermostat with automatic and manual reset
- Safety class IP43
DIMENSIONAL DRAWING AND CONNECTIONS
Dimensions in mm
DIAGRAM
Pressure losses by electric post-heating battery
WWW.VASCO.EU
90.01.07.21
01 / 2024
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>