EZVALO LR2 Puck Pro Under Cabinet Light User Manual
- June 1, 2024
- EZVALO
Table of Contents
EZVALO LR2 Puck Pro Under Cabinet Light
Product accessories
Installation
- Best for smooth surface, wipe clean with a damp cloth.
- Remove the adhesive liner. Apply the mounting disk to the surface.
- Attach the light.
How to use
light
Remote Control
- Before use, pull out the plastic sheet.
- The light will flash once each time the timer is set successfully.
SPECIFICATION
- Size: Ф85 X 33mm/Ф3.3X1.3in
- Model: LR2
- weight: 92g/3.2 oz
- LED Power: 0.6W
- Power Input: 5V=1A
- Motion sensor Range: 3m/10ft
- PIR Detection Angle: 120°
- Lifespan: 30,000 + h
- Battery: 1200mAh
- Materials: ABS+PC
- working Temperature: 0~40°C/32~104°F
- working Humidity: 0%~85%RH
Attention
- DO NOT Expose to Liquids!
- DO NOT Disassemble!
- AVOID Dropping!
- AVOID Extreme Heat and Humidity!
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
ISED Canada Statement
This device contains licence-exempt transmitters)/receivers) that comply with
Innovation, Science and Economic Development
Canada ‘s licence-exempt RSS(s). Operation is subject to the following two
conditions:
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure: This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment
RF Exposure Statement
To maintain compliance with IC’s RF Exposure guidelines, The installation and operation of the device should meet the requirements for portable devices. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>