EZVALO LR1 Rechargeable Puck Light User Manual

EZVALO LR1 Rechargeable Puck Light

Features

1. Hand Wave Activation
2. Remote Control
3. Group Mode
4. Rechargeable
   

Installation

1. Best for smooth surface, wipe clean with a damp cloth.
   

2. Remove the adhesive liner. Apply the mounting disk to the surface.
   

3. Attach the light.
   

Using the Device

Remote Control

Note: The remote control can be purchased separately if needed.

Specifications

Troubleshooting

1. Drained battery
2. Switch is at “OFF” position.

|

1. Recharge the light until the indicator turns green.
2. Toggle the switch to the “l” or “2” position.

Remote control does not work.|

1. Lights are out of range.
2. Low on battery.

|

1. Make sure that the lights are within a range of 10 meters without obstructions.
2. Replace the battery on the remote control.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

EZVALO Customer Service
Email: service@ezvalo.com
MADE IN CHINA

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>