DWVO FTHKCT-0022 Rustic Bathroom Vanity Instruction Manual
- June 1, 2024
- DWVO
Table of Contents
DWVO FTHKCT-0022 Rustic Bathroom Vanity
ASSEMBLY INSTRUCTIONS DGRT-V1
Model: FTHKCT-0022; FTHKCT-0023
Notice:
1. Please unbox the item from the side with an open label and put a carpet on
the floor to avoid scratching it.
2. Follow the installation instructions carefully. Before installation,
please ensure that all accessories are present. For large items, we advise you
to install them with 2 or more people for faster and safer installation.
3. Do not fully tighten the screws during initial assembly.Fully tighten the
screws only once all pieces are correctly assembled. Do not use power tools.
4. Do not stand, climb, or swing on the product.
5. If you encounter any problems during installation, please contact our
customer service.
Explosion Diagram
STEP-1:
Screw driver not included.
Step-2:
Cam Lock Placement Supplement
Step-3:
Step-4:
Step-5:
Step-6:
Step-7:
Do not fully tighten all screws
Step-8:
Do not fully tighten all screws
Step-9:
Do not fully tighten all screws
Step-10:
Fully tighten all screws using wrench # J
Step-11:
Step-12
Please refer to hinge adjustment supplement next page
HINGE ADJUSTMENT SUPPLEMENT
In the event that the door does not align properly, the INSIDE Machine Screws
located on the Hinges are for adjusting slightly to the Left or Right. DO NOT
LOOSEN THE OUTSIDE MACHINE SCREW FOR ADJUSTMENT.
A. To adjust the door toward the OUTSIDE of the unit, turn the Inside Machine
Screws to the LEFT, or COUNTERCLOCKWISE. (See Figure A)
B. To adjust the door toward the INSIDE of the unit, turn the Inside Machine
Screws to the RIGHT, or CLOCKWISE. (See Figure B)
*Note: Please be patient, it may take several minutes to adjust properly.
Only once the door is in the desired position, fully tighten the OUTSIDE
Machine Screws. This will ensure that the door 1s secure.
Step-13:
Step-14:
Attention: For safety and stability, we suggest you have to secure the anti- tip accessories to the wall to prevent tipping, injury, and property damage.
Insta||ation Comp|etedI
Specifications:
- Model: DGRT-V1
- Parts: FTHKCT-0022, FTHKCT-0023
- Number of Screws: 4 pcs
- Wrench Type: J
Assembly Instructions:
- Use the provided screws and wrench (J) to assemble the product.
- Fully tighten all screws using the wrench.
- Repeat the assembly steps for another door if applicable.
Hinge Adjustment Supplement:
In case the door does not align properly, follow these steps:
- To adjust the door towards the outside of the unit, turn the inside machine screws to the left or counterclockwise.
- To adjust the door towards the inside of the unit, turn the inside machine screws to the right or clockwise.
- Be patient as it may take several minutes to adjust properly.
- Once the door is in the desired position, fully tighten the outside machine screws for security.
Anti-Tip Accessories:
For safety and stability, it is recommended to secure anti-tip accessories to the wall to prevent tipping, injury, and property damage.
Installation Completed:
Ensure that installation is completed according to the provided instructions before use.
FAQ
Q: How do I know if the product is properly assembled?
A: Check that all screws are fully tightened using the provided wrench and ensure proper alignment of the doors.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>