VISUAL COMFORT CHD 2526 Parkington Double Library Wall Light Installation Guide
- June 3, 2024
- VISUAL COMFORT
Table of Contents
VISUAL COMFORT CHD 2526 Parkington Double Library Wall Light
ASSEMBLY INSTRUCTIONS
Parkington Double Library Wall Light
- Item # CHD 2526
NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED)
- Phillips Screwdriver
- Slotted Screwdriver
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from fixture by removing screws (D).
-
Install mounting plate (B) to the junction box and secure with the mounting screws (C).
-
Wrap fixture ground wire (bare copper) around the green grounding screw (see diagram 1). Tighten. Continue fixture ground wire and connect to supply ground wire (usually green or bare copper) using wire nut (A).
NOTE: It is imperative that the fixture is grounded. -
Connect fixture neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
-
Connect fixture hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION: Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck into the junction box.
-
Install fixture to mounting plate (B) by securing with screws (D).
-
Install light bulb into the socket.
-
Loosen thumb screws (G) and insert top of shade (F), then secure with thumb screws (G).
NOTE: Do not overtighten otherwise shade could become damaged. -
To adjust fixture loosen knobs (H), adjust to desired position, then tighten knobs (H).
Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.