TYGER TG-LX3T82338 LanderX Running Board Installation Guide
- June 1, 2024
- TYGER
Table of Contents
TYGER TG-LX3T82338 LanderX Running Board
BEFORE INSTALLATION
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. FAILURE TO IDENTIFY DAMAGE BEFORE INSTALLATION COULD LEAD TO A REJECTION OF ANY CLAIM. IF MISSING PARTS OR ANY DAMAGE FOUND, PLEASE TAKE A PICTURE FOR THE CLAIM PURPOSE. TO FILE YOUR CLAIM, PLEASE VISIT: WWW.TYGERAUTO.COM/CONTACT
TORQUE VALUES
Fastener Size| Class 8.8 Torque (ft-lbs)| Class 10.9 Torque (ft-
lbs)
---|---|---
6mm| 6-7| 6-7
8mm| 15-16| 22-23
10mm| 31-32| 44-45
12mm| 54-55| 78-79
14mm| 87-88| 125-126
PART LIST
- x1 Driver/Left TYGER LanderX
- x1 Passenger/Right TYGER LanderX
- x1 Driver/Left Front Mounting Bracket
- x1 Passenger/Right Front Mounting Bracket
- x2 Driver/Left Center/Rear Mounting Brackets
- x2 Passenger/Right Center/Rear Mounting Brackets
- x12 8mm x 30mm Hex Bolts
- x12 8mm x 25mm Combo Bolts
- x12 8mm Lock Washers
- x12 8mm spacers
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
- READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
STEP 1
Starting on the driver/left front of the vehicle, remove the plastic plugs,
(or hex bolts), covering the threaded holes in the body panel (Fig 1). Select
the Driver/Left Front Mounting Bracket. Attach the Bracket to the vehicle with
(2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers (Fig 2). DO
NOT tighten hardware.
(Fig 2) Attach the Driver/Left Front Mounting Bracket to the front mounting
location
STEP 2
Move along the body panel to the center mounting location. Select (1)
Driver/Left Center/Rear Mounting Bracket. Repeat STEP 1 to install the
Mounting Bracket (Figs 3 & 4). DO NOT tighten hardware.
(Fig 3) Driver/Left center mounting location
(Fig 4) Attach (1) Rear Mounting Brackets to the center and rear mounting
locations
STEP 3
Continue to the last mounting location at the back of the cab (Fig 5). Select
(1) Driver/Left Center/Rear Mounting Bracket. Repeat STEP 1 to attach the
Bracket to the rear mounting location. DO NOT tighten hardware.
STEP 4
Select the Driver/Left TYGER LanderX. Attach the TYGER LanderX to the (3)
Mounting Brackets with (6) 8mm Combo Bolts (Fig 6). DO NOT tighten hardware.
STEP 5
Level and adjust the TYGER LanderX, then tighten all hardware.
STEP 6
Repeat STEPS 1-5 to attach the Passenger/Right TYGER LanderX.
STEP 7
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
CUSTOMER SUPPORT
Customer Support: www.tygerauto.com/contact
TG-LX3T82338
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>