itel A665L 3GB RAM + 128GB ROM Smart Phone User Manual

itel A665L 3GB RAM + 128GB ROM Smart Phone

Specifications

• Model: A665L
• Operating System: Android™
• Front Camera
• Volume + key
• Volume – key
• Power key & side fingerprint sensor

Product Usage Instructions

Know your phone

The phone features a front camera, volume control keys, and a power key with a side fingerprint sensor.

SIM/SD Card Installation

1. Power off the mobile device.
2. Refer to the provided picture for SIM/SD card installation guidance.

Charging the Phone

To charge the device, use the provided charger or connect it to a computer using the included USB cable. It is recommended to use only itel chargers and cables to avoid damaging the device, which could void the warranty.

FAQ

What should I do if my phone is not charging?

• If your phone is not charging, try using a different charger or cable to rule out any issues with the charging accessories. If the problem persists, contact customer support for further assistance.

How do I enable the fingerprint sensor on my phone?

• To enable the fingerprint sensor on your phone, go to the settings menu, select the security or biometrics option, and follow the on-screen instructions to set up and activate the fingerprint sensor for unlocking your device.

Explosion diagram specification

Know your phone

1. Front Camera
2. Volume + key
3. Volume – key
4. Power key& side fingerprint sensor

SIM/SD card installation

1. Power off mobile.
2. Refer to the following picture for SIM / SD card installation.

Charging the phone

• You can charge your device using a charger or by connecting it to the computer using a USB cable (which comes with the phone).
• Use only itel charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty.

FCC Caution

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
2. This device may not cause harmful interference.
3. This device must accept any interference received, including interference that may cause undesired operation.
4. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Specific Absorption Rate (SAR) information:

This mobile phone meets the government’s requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement The SAR limit of the USA (FCC) is 1.6 W/kg averaging over one gram of tissue. Device types: A665L(FCC ID: 2AJMN- A665L) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.180 W/kg and when properly worn on the body is 0.491 W/kg.

Body-worn Operation

• This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the user’s body and the handset, including the antenna.
• Third-party belt clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided.
• Use only the supplied or approved antenna.
• Operating System AndroidTM
• Android is a trademark of Google LLC.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>