VEVOR SKU1-S100 Single Monitor Mount User Manual

VEVOR SKU1-S100 Single Monitor Mount User Manual

NEED HELP? CONTACT US!

Have product questions? Need technical support? Please feel free to contact us:
This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won’t inform you again if
there are any technology or software updates on our product.

SAFETY INSTRUCTIONS

WARNING:

Read this material before using this product. Failure to do so can result in serious injury.

Assembly precautions

1. Assemble only according to these instructions. Improper assembly can create hazards.
2. Keep the assembly area clean and well-lit.
3.  Keep bystanders out of the area during assembly.
4. Do not assemble when tired or when under the influence of alcohol, drugs or medication.
5.  The product capabilities apply to properly and completely assembled products only.
6.  For additional information regarding the parts listed in the following pages, please refer to the Assembly Diagram of this manual. Unwrap and separate all parts in a clean work area.

Use precautions

1. Use with products heavier than the rated weights indicated may result in instability causing possible injury.
2.  Mounts must be attached as specified in assembly instructions. Improper installation may result in damage or serious personal injury.
3.  Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
4. Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
5. This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
6. This product is intended for indoor use only. Using this product outdoor could lead to product failure and personal injury.

PRODUCT PARAMETER

PARTS LIST

ASSEMBLY STEP

Method 1 —– 1a

Method 2—- -1b
(Desktop has a hole for item 2 to go through)

nect With Monitor

Start by screwing the panel to the correct angle for easy placement of the monitor

Use a spanner (F) to screw thescrews (A/B) and washers (D) into the two holes on the upper back of the display, and then screw the VESA plate into the two holes on the lower end
. Avoid excessive tightening screws damage the monitor.

Case 1:

Monitor/Arm fal down (after installyour monitor) Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.Turn counter-clockwise( + direction) to increase gas spring tension till can hold the weight of your monitor. Note: You may need to turn the screw by many circles to tighten the arm.

Case 2:

Monitor/Arm pops up (after install your monitor) Press the arm to make it keep it in horizontal position and then use the Allen Key to adjust the screw on the arm.Turn clockwise(” – * direction) to reduce gas spring tension till can stay the position needed. Note: You may need to turn the screw by many circles to tighten the arm.

Cable lmanagement

Adjustable instruction

Address: Baoshanqu Shuangchenglu 803long 11hao 1602A-1609shi Shanghai
Imported to AUS: SIHAO PTY LTD, 1 ROKEVA STREETEASTWOOD NSW 2122 Australia
Imported to USA: Sanven Technology Ltd.Suite 250, 9166 Anaheim Place, Rancho
Cucamonga, CA 91730

SHUNSHUN GmbH EC | REP | Rémeracker 9 22021,76351
Linkenheim-Hochstetten,Grmany

Pooledas Group Ltd
UK [ REP | unit 5 Albert Edward House, The Pavilions
Preston, United Kingdom

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>