SIMPLE DELUXE B0BCFBKCKD Trampoline for Kids with Safety Enclosure Net User Manual
- May 15, 2024
- SIMPLE DELUXE
Table of Contents
SIMPLE DELUXE B0BCFBKCKD Trampoline for Kids with Safety Enclosure Net
DISCLAIMER
WARNING!
Please read these instructions before starting to assemble the trampoline. Incorrect assembling might cause damage to the trampoline.
ADULT SUPERVISION GUIDANCE REQUIRED AT ALL TIMES.
Recommended age 6+ years.
- Max user weight limit: 398 lbs
- Not suitable for children under 36 months-small parts, choking hazard.
- The trampoline must be assembled by an adult in accordance with the assembling instructions.
- The trampoline is intended for outdoor use only.
- Do not use the mat when it is wet.
- Only one user at a time. Danger of Collision hazard.
- Always close the net opening before jumping.
- Jump without shoes.
- Empty pockets and hands before jumping.
- Always jump in the middle of the mat.
- Do not eat while jumping.It is advisable not to bounce immediately after ameal.
- Do not exit by a jump
- Do not use in strong wind conditions and secure the trampoline.
- Limit the time of continuous usage (make regular stops).
ADVISORY
- This trampoline is not intended to be buried in the ground.
- The trampoline must be placed on a level surface at least 2m from any structures or obstructions such as fence, garages, house, overhanging branches, laundry lines or electrical wires.
- Do not install the trampoline over concrete, asphalt or any other hard surface. Also not in proximity of other conflicting installations, such as padding/swimming pools, swings, slides or climbing frames.
- Any modifications made by the consumer to the original trampoline (e.g. the addition of an accessory) shall be carried out according to the instructions of the manufacturer.
- Inspect trampoline/enclosure net before each use.
- If an access ladder is used it should be removed when the trampoline is not in use.
- Make sure there are no children/animals/obstructions underneath the trampoline.
- Access the trampoline through the door of the enclosure net only. Make sure you securely close it before bouncing. Use: Ensure the door is securely closed before bouncing.
- Don’t intentionally rebound off the enclosure net as this will weaken it.
- Only attach manufacturer-approved accessories to the trampoline and enclosure net.
- Always jump in the middle of the mat and practice bounce techniques safely with adult supervision and guidance.
ASSEMBLY AND MAINTENANCE INSTRUCTIONS
-
Attention to the need to carry out checks and maintenance of the main parts (frame, suspension system, mat, padding, and enclosure) at the beginning of each season and also at regular intervals of every 2 weeks,
pointing out that if these checks are not carried out, the trampoline could become dangerous. -
Check all nuts and bolts for tightness and tighten when required.
-
Check that all spring-loaded (pit pin) joints are still intact and cannot become dislodged during play.
-
Check all coverings and sharp edges and replace when required.
-
Retain the maintenance instruction manual.
-
Outdoor trampolines should be equipped with a device that in strong wind conditions avoid displacement due to wind (e.g. steel bars in the ground or loads like sand bag or water bags) and/or items catching wind like net and mat should be removed.
-
In certain countries during winter periods, the snow load and the very low temperature can damage the trampoline. It is recommended to remove the snow and store the mat and the enclosure indoors.
Check that mat, padding, enclosure and soft surface are without defects. -
NOTE: Sunlight, rain, snow and extreme temperatures reduce the strength of these parts over time.
-
Make sure that the hook-and-loop fasteners are closed correctly during use of the trampoline!
-
The trampoline and net should be packed away in winter. Make sure all parts are dry and packed securely. Store dry to support product longevity. Always be aware of wear and tear due to weather and wind.
-
We recommend securing the trampoline in strong winds. Tie the trampoline down with ropes attached to the trampoline pad. Tie the trampoline down in a minimum of three places distributed evenly across the trampoline frame.
-
Do not secure the legs as these may become misaligned and ruin the trampoline. Dismantle or remove the trampoline completely, if required. It may result in great danger if the trampoline is not secured in strong winds.
-
If the trampoline is not used for short periods of time and to avoid jump mat debris caused by fallen leaves and twigs, It’s recommended usage of a Weather Cover. When the trampoline is not used for a longer period of time (e.g. during the winter). It’s recommended to store the trampoline, especially the protective padding, in a dry area to support product longevity.
MOVING INSTRUCTIONS
- Make sure the trampoline is placed on level ground. Uneven ground surfaces may cause the trampoline frame to warp.
- Make sure that all bolts holding the frame joints are tightened completely before installing the springs. Failure to do this properly will cause the frame to warp.
- Make sure NOT to use one’s leg to push against the trampoline leg or frame when loading the springs. It will cause the trampoline to warp.
- DO NOT load the springs onto the frame on only one side of the trampoline. Uneven distribution of tension from the springs will cause the frame to warp.
- If the trampoline frame warps up, do not be alarmed as the “Quad-lock” system is designed to be flexible. Push down on the part of the frame that warped with two people as shown. The frame will level out.
- Moving trampoline. If the trampoline and enclosure needs to be moved, it should be moved by two persons at least, kept horizontal, and lifted slightly. If necessary, the trampoline and enclosure can be taken for moving. To take the trampoline apart, follow the assembly steps in reverse order.
If you need to move the trampoline, two people should be used at least. All connector points should be wrapped and secured with weather-resistant tape, such as duct tape. This will keep the frame intact during the move and prevent the connector points from dislocating and separating. When moving, lift the trampoline slightly of the ground and keep it horizontal to the ground. For any type of other move, you should disassemble the trampoline.
WARNING!
2 adults in good physical condition are required for the following assembly. Wear proper shoes and maintain balance to preven a fall. Failure to follow all instructions and warnings exactly may result in serious injury.
PARTS LIST
TRAMPOLINE ASSEMBLY
STEP 1
Attaching two Leg Extensions (F) to U-shaped Legs (G), Fix with the screw (T), and Repeat this step for all of the legs. pre-install (The T-connector joint has been pre-installed on the coil tube at the factory, if it falls off during transportation, please install it according to the instructions. 8FT Trampoline No Leg Extensions)
When you are assembling the U-shaped legs make sure the holes on the posts you are attaching are facing INWARD before you screw them to the U shaped legs.
Begin by attaching Top Rails (c) to T-connectors (D). Continue until you form a large circle.
Tip: Have a second person or use a wall to apply some resistance against the frame to help it shift into place.
Two people will be necessary at this point to assemble the trampoline. One person lifts up the circle frames. The other person lifts the U-shaped leg tubes to a standing (vertical) position and inserts the T-connectors into a U-shaped leg tubes. Ensure the locking holes are aligned.
STEP 2 – TRAMPOLINE POLE TUBE ASSEMBLY
Firmly fix the Bottom Tube (K) to the leg extension with the Screw A&C (M&X), then fasten the fork screw by a wrench.
Repeat above procedures, and set up all of the Bottom Tube (K) on the trampoline.
WARNING!
2 adults may be required to complete placement of all springs. Springs will create high levels of tension when assembled. Please take care not to pinch your fingers.
Lay out the Jumping Mat (B) inside the frame. Ensure the holes are facing inside.
Before installing the jumping mat with spring, please make sure that the SCREW in the “T” connector & U-Shaped feet on the trampoline frame are all tightened, and the U-shaped feet will not fall off during any movement of the trampoline frame.
Putend ‘a’ of the spring into trampoline Jumping Mat (B) rings, then take Spring (E) and insertend ‘b’ into top rail tube.
Hold Spring Tool (H) overhand and pull spring hook towards Top rail (c) as the picture shown: drop hook into frame hole until it latches on completely, tap it down if hook is not completely in the hole.
TAKE CARE
It is Not allowed Foot step on the curved tube when you assemble OR jumping!
Footstep only on the ” T” connector if necessary when you assemble OR jumping!
Stand on the ladder may help you when you assemble the top of the safety Net and Poles! (move ladder for each safety poles)
WARNING!
Springs must be installed on top rail in this right way around, and fully inserted into the hole on the top of the frame. See the picture below. The placement of the next spring must be on the opposite side of frame, then center adjacent, then the opposite. It must be done this way so the tension of the spring is spread equality.
Lay out the Jumping Mat (B inside the frame. Ensure the holes are facing inside, Lay Frame Cover (A) on outer edge, so springs are covered. It should be fitted like a shower cap. Please ensure it covers all metal parts.
As shown in the picture, put all of the Upper Tube (L) into the sleeves, and make them lay horizontally on the Jumping Mat (B) . Please notice it is the side with plastic caps that you should put into sleeves.
Match all of the Upper Tube (L) with the already-installed Bottom Tube (K) by order. Please slightly drag the Enclosure Net (P) down and hook with V-rings on the Jumping Mat (B) after ensuring that all of those net poles are well connected.
STEP 2- ATTACH THE LADDER (8FT Trampoline No Need Ladder)
WARNING!
Test the steps to make sure they are strong. Find the doorway to your safety net. Lift up your safety pads and place tho hooks of the ladder over your trampoline curved pole.
Contact
please contact us first if you have any concerns of our product and we will make it right for you.
- Brand: Simple Deluxe
- Add: 2399 Bateman Ave Irwindale, CA91010
- Tel: 626-756-4797
- Toll Free: 866-558-2976
- Email: cs@simpledeluxe.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>