ATUMTEK Single Monitor Gas Spring Desk Mount Instruction Manual

June 4, 2024
ATUMTEK

ATUMTEK Single Monitor Gas Spring Desk Mount

PRODUCT LINE GRAPH

ATUMTEK Single Monitor Gas Spring Desk Mount-1

  • Arm
  • Steel Pipe
  • Cable management cover
  • Locating Ring
  • Bottom steel plate
  • Base
  • Clamp
  • Clamp Screw

PARTS INCLUDED

ATUMTEK Single Monitor Gas Spring Desk Mount-2

Mount the Base on Desk

Desk Side Installation (Desk Thickness s 8.5 cm.)

ATUMTEK Single Monitor Gas Spring Desk Mount-3

  • Measure the thickness of the desktop, unscrew the clamp screw then install the clamp on the desktop and tighten it Use the 3 mm hex key wrench to fasten the screw on the back of base.ATUMTEK Single Monitor Gas Spring Desk Mount-4
  • IF space is still not enough for clamp, reverse the bottom steel plate to try again; First remove the clamp screw and attachment entirely, and upside-down the bottom steel plate, then reattach clamp screw with attachment and install the bottom steel plate back Finally tighten the clamp screw to install the base on desk.

Desk Grommet Installation

ATUMTEK Single Monitor Gas Spring Desk Mount-5

  • First use the right hex key wrench to loosen the screws and the black plastic cushion on the base.ATUMTEK Single Monitor Gas Spring Desk Mount-6
  • Use the 4 screws just removed to assemble the grommet plate on the aluminum base, then attach the plastic Cushion on the base Remove the desk grommet and fasten the clamp screw through the grommet hole.
    NOTE: Remember to fasten the screw on the back of the base with 3 mm hex key wrench.

Mount the Arms

  • Adjust locating ring at proper height and tight it to hold the arm.ATUMTEK Single Monitor Gas Spring Desk Mount-7
  • Install the cable management cover on arm first Then insert the arm to the steel pipe above the locating ring Finally tight the locating ring at suitable height, and fasten the screws to hold the arm frmly.ATUMTEK Single Monitor Gas Spring Desk Mount-8

Install the Monitor

  • First remove the monitor attachment entirely.ATUMTEK Single Monitor Gas Spring Desk Mount-9
    Note: Please check computer manufacturer user book for details.

  • Flush surface monitor installation: Use 4 screws to install the VESA plate on the monitor rear.ATUMTEK Single Monitor Gas Spring Desk Mount-10

  • Curved monitor rear installation: Put 4 spacers on monitor rear. Install 4 screws through VESA plate, spacers. Then mount the VESA plate on curved monitor rear. Adjust the screws to ensure the VESA plate is lat.ATUMTEK Single Monitor Gas Spring Desk Mount-11

  • Lift the monitor, pull the metal sheet on monitor holder, then put the VESA plate into the slot to hang the monitor on arm.ATUMTEK Single Monitor Gas Spring Desk Mount-12

  • Keep the arm in horizontal position, then usea hex wrench to adjust the height tension of the gas spring arms, to ensure the arm can support ditferent monitors horizontally at any position.ATUMTEK Single Monitor Gas Spring Desk Mount-13

  • Use the 5 mm hex wrench to adjust the monitor holder damp. Turn counter-clockwise to reduce damping and clockwise to increase damping.ATUMTEK Single Monitor Gas Spring Desk Mount-14

  • Insert cables into cable management covers, use clip to hold cables at the bottom, and leave enough cables at arm joints to enable free adjustment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals