ATUMTEK ATRL157 RGB Video Light Portable LED Camera Light User Manual
- June 14, 2024
- ATUMTEK
Table of Contents
ATUMTEK ATRL157 RGB Video Light Portable LED Camera Light
Product Introduction
- Product Size: 1659528.5 mm
- CRI (Ra) 90
- Power: 4 W
- Input: 5V/1A
- Battery Capacity: 2000 mAh
- Color Temperature: 2900-670DK
- ATTENTION : Built-in battery type
- Do Not Suggest to use directly by connecting USB cable.
Package Includes
Indicator Light Status
4 red lights ON
| Battery capacity
around 100%;
---|---
3 red lights ON| around 75%;
2 red lights ON| around 50%;
1 red light ON| around 25%;
1 red light FLASHING| Low battery!!!
Need to recharge video light.
- Brightness”-“( 5 levels Adjustment)
- ON/OFF Button & Light Mode Toggle
- Brightness”+” (5 levels Adjustment)
- Charging Port
- Battery Level Indicator Light
Step 1 LED Video Light Using Gulde
Switch ON/OFF
Long press ON/OFF button for 2 seconds to turn light on/off.
Choose Light Mode
When light is on, lightly press Light Mode Toggle button {ON/OFF button) once
to choose light mode/ colors. In total 3 Light Mode to choose, Cold LighVWarm
LighV Cold& Warm Light. And 7 colors to choose from, red, yellow, green, cyan,
blue, purple, pink. Also when you turn off and then switch on the video light
again, the memory function will still remains the same light mode as last
time.
Brightness Adjustment
When light is on, press”+” or “-“to adjust light brightness. There are 5
brightness levels to choose on each side.
sos Mode
When light is off, long press”+” button for 5-8 seconds, light will flashes
regularly and enter SOS mode; Long press ON/OFF button for 2 seconds to turn
off SOS mode.
Charging & Battery Capacity
Red charging indicator Light flashes while charging, and it will be
permanently on after fully charged. Once fully charged, video light can use
for 2 hours.
Step 2 Install Accessories on Video Light
Install clip on the bottom of the light tighten the screw to secure it ; Then clip the light on the computer or laptop screen, near the camera.
Or aim the 1/4″ screw connector at the screw hole, and tighten the screw to fasten it. Then mount the video light on other parts with cold shoe.
IC Warning
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment_ This
device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correa the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radionv technician for help.
To access this ATUMTEK product Instructions In different languages. please scan the OR code provided. Once scanned, you’ll be directed to a PDF document which you can open In your browser and download for your reference.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>