ATUMTEK ATSS067 58.7 Inch Selfie Stick Tripod with Bluetooth Remote User Manual
- June 6, 2024
- ATUMTEK
Table of Contents
ATUMTEK ATSS067 58.7 Inch Selfie Stick Tripod with Bluetooth Remote
PRODUCT LINE GRAPH
Product Parameters
-
Weight
Approx.410g -
Remote distance
<10m[33ftJ -
Ambient temperature
-10’C-50 C -
Remote battery capacity
50 mAh -
Input
5V/110 mah -
Compatible devices
105 7. 0 and later/Android 5.0 and later -
Device width
Approx. 2.36′ – 3.74″ -
Extended length w/o tripod activated
Approx. 13.8″ -58.3″ -
Extended length with tripod activated
Aporox.13. 2″-58.7″ -
Folded Sile
Approx 7 28″ * o· .57 -
Remote button lifespan
15,000 times
How to take out/ put In wireless Bluetooth remote
- Take out from the Remote bottom
- Put back from the top of the Remote
How to use
Step 1 · First pull out the phone holder, then press the tripod button on
bottom to unlock the 3 legs slightly
ATTENTION
When you press the bottom button, please avoid to hold the top of
tripod. Step 2: Now pu I
the whole stick arm out, and the tripod will open automatically
ATTENTION
Please fully pull out the stick arm so that the tripod can be fully opened
Otherwise, tripod is not fully opened and will not be stable Step 3: Extend the adjustable stick arm to
suitable height accordirg to your demands;360° Horizontal Rotation of Phone Holder; 180°
Vertical Rotation of Adjustable Bracket.
step 4 : widthwise set your phone inside the smartphone holder by
releasing the top cap.
Note: Please avoid stuck your phone button. And do not overextend phone
holder in case to break it.
How to Close
Step 1: remove your mobile phone by releasing the top cap step 2 : Hold
the bottom part of stick, then pull back the extendable stick one by one;
finally push the phone holder back. Note: If you open the tripod, the tripod
will close automatically when push back the aluminum alloy telescopic arm.
Manual operation is prohibited.
WARNING:
Do not push the 3 legs to close!!! It will break legs!!!
NOTE:
- Open your built-In G’lmera In your pho1e and press the power & camera 2 In 1 button of once for taking a photo
- The wireless Bluetooth remote will connect directly after switch on if it is already connected with t1e phone Bluetooth in last time.
- The Bluetooth will automatically d·sconnect when the distance is greater than or equal to 10 meters
- Tum the Bluetooth off in your phone and t1e wireless Bluetooth remote will stardby
- How to disconnect with your phone: Go to your prone Bluetooth setting and disconnect “ATU\HFK” In paired devices
- Unavailable to use to control the built-in camera app In your p1one when the wireless Bluetooth remote in charging
Bluetooth Connect Instruction
*6 It takes about 2 hours to fully charge the remote
First Long press the camera button for 2 seconds. then connect with “ATUMTEK”
when green light is flashing finally press once to take a picture or record
video.
if phone could not connect clean phone Android phones use volume button
control camera, so if you still could not use remote, please choose ‘take a
picture” or take a video” on camera setting part Or please contact wi:h seller
directly to get support.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>