ELIVED MU9132#27 Universal Floor Speaker Stands Instruction Manual
- May 15, 2024
- ELIVED
Table of Contents
Speaker Stand
Instruction Manual
If you have any questions, please feel free to contact our customer support before returning.
**** Safety Caution
BEFORE ASSEMBLY
- Layout all components and hardware. Check all parts are included and undamaged.
- Should anybody intends to install or use this mount, please read and understand this manual carefully.
- If you do not understand these instructions or have any doubt about the safety instructions, assembly or use of this product, please contact our customer service.
WARNING
- This product contains small items that could be a choking hazard if swallowed.
- KEEP AWAY FROM CHILDREN UNDER 3 YEARS OLD. ADULT SUPERVISION IS REQUIRED.
- Improper installation, such as using the product for monitors over its load capacity or for any purpose not explicitly specified, may cause damage or serious injury. We would not be liable for any damage or injury caused by improper mounting or inappropriate use.
CAUTION AND MAINTENANCE
- Never allow children to climb, stand, hang, or play on any part of speaker or stand.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Check that the bracket is secure and safe to use at regular intervals (at least every three months).
PACKAGE CONTENTS
Hardware
Hardware for stand assembly
ASSEMBLY STEPS
STEP 1: Install the base foot pad
Choose rubber feet or carpet nails according to your floor type.
Option One: If the stand is placed on wooden, cement, tile or other hard
floor, install the foot pad H and adjust them to level if the base is not
level.
Option Two: If the stand is placed on
carpet, install the carpet nails I,and adjust them to level if the base is not
level.
STEP 2: Install the bottom tube
- Insert Bottom tube 3 into Base 2, then fasten Bolt C by using Allen key F
.2) Insert into Base 5. Plastic cover
2. STEP 3:Install the upper tube
AInsert Upper tube into 4 bottom tube 3, then fasten Bolt A by using Allen key F.
STEP 4: Install the board
Place Board 1 onto Upper tube 4 and align its threaded holes with the holes on the flange plate. Install Screw B by Allen key F. Adjust the board to the left or right so that it is parallel to the base before tightening these screws.
STEP 5: Install non-slip mat
Remove the film of the adhesive,and stick non-silp mat G according to the size of speaker.
STEP 6: Install Speakers
Insert the plug into the circular hole and pull it out from the hole under the base.
Product Dimensions
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>