ELIVED YD5001 Projector Laptop Tripod Stand Instruction Manual

May 15, 2024
ELIVED

**ELIVED YD5001 Projector Laptop Tripod Stand Instruction Manual


**

Thank you for choosing this product! If you have any questions, please feel free to contact us via Amazon before returning.

Safety Caution

Please read this instruction carefully before installation.
If you do not understand these instructions or have doubts about the safety of the installation, assembly or use of this product, please contact us via Amazon.

  • Incorrect installation may result in product damage or body injury.
  • Do not use this product for any purpose that is not explicitly specified in this manual.

WARNING: This product contains small items that could be a choking hazard if swallowed.
Before starting assembly, verify all parts are included and undamaged. If any parts are missing or damaged, do not return the damaged item to your dealer; please contact our customer service team. Never use damaged parts!

Supplied Parts and Hardware

  • Pillar A (x1)
    Supplied Parts and Hardware

  • Foldable Tripod Stand B (x1)
    Supplied Parts and Hardware

  • Tray C (x1)
    Supplied Parts and Hardware

  • Connector D (x2)

  • M6x18mm Bolt E (x4)

  • M6 Flange Nut F (x4)

  • Open-end Wrench G (x1)

  • 1/4”-20 Bolt H (x1)

  • Strap I (x2)

  • Phone Holder J (x1)

Phillips Screwdriver (Not Included)

Adjust the Height of the Tripod

Unfold the tripod stand and adjust to your preferred angle, then tighten the knob.
Adjust the Height of the Tripod

WARNING When you unfold or fold the tripod, please be careful and avoid pinch areas such as the upper section of the supporting leg.

DO NOT
place hands on or near the joints of the supporting leg.

When you adjust the pillar to your desired height, tighten the knob, then insert the safety pin into the hole on the pillar.
Adjust the Height of the Tripod

Secure the Tray to the Connector

Note:
The connectors should be pre-tightened but still moveable for Step 2-2 to align with the tray.
Secure the Tray to the Connector

Connecting the tray and connector by using bolts (E) and flange nuts (F), tighten them with the open-end wrench (G) and fillips screwdriver.


Note:

  • The holes in the connector should be aligned with the holes on the tray.
  • Do not tighten the bolts (E) until all of them are in right positions.
    Secure the Tray to the Connector

Tilt Adjustment of Tray

Adjust the tray to your desired tilt angle, then tighten the knobs to secure the tray in place.
Tilt Adjustment of Tray

Install Phone Holder

Install the phone holder (J) by using bolts (H), and tighten with fillips screwdriver.
Install Phone Holder

Secure the Device with Strap

Secure the Device with Strap

Specification

Dimensions

ELIVED Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals