INFINITY HDTS-002 Heavy Duty Tool Stand Instruction Manual
- May 15, 2024
- Infinity
Table of Contents
INFINITY HDTS-002 Heavy Duty Tool Stand
Product Overview
Congratulations on choosing Infinity Tools Heavy Duty Tool Stand. We believe you will find this product to be among the sturdiest and most durable tool stands in your workshop. This tool stand can be assembled in a variety of configurations allowing for working heights from approximately 22-1/4″ – 23-3/4″ / 25-1/4″ – 43-3/4″ with the included levelling feet (25/28″ – 45″ in 1″ increments with optional caster set) not including top. Depending on your desired configuration, all nuts, bolts, rails, and leg sections may not be needed.
Stand Components
- 4x Lower leg sections
- 4x Upper leg sections
- 6x Front/back rails 46″
- 6x Side rails 21-1/2″
- 1x Leveling feet with hardware
- 64x Hardware Pack containing 64x stainless carriage bolt & 64x stainless flange nuts
- 1x Hardware Pack Containing 20x Phillips head wood screws
Assembly Instructions
Step 1: Leg Assembly
Starting with the leg assemblies, set the length of the legs to the desired height with the lower leg section inside the upper leg section. Take note that the included leveling feet will add a minimum of 1-1/2″ to the stand height and allow for an additional 1-1/2″ of height adjustment.
Step 2: Installing Rails
Install the rails inside the leg assemblies using (2) carriage bolts and (2) flange nuts at each junction. Tighten the hardware only hand tight. The center rails can be positioned and used to support a shelf. If the center rails are not being used, be sure to attach the upper and lower leg sections using at least (2) nuts/bolts on each face. Each stand includes two front/back rails with the Infinity Tools logo. These can be positioned wherever you would like. We recommend using them either as the top or middle rails to display the Infinity Tools name with pride.
Step 3: Square, Tighten & Install Feet
Square the stand assembly and tighten all hardware. Install the levelling feet into the legs so that one nut is above and one below the mounting flange. Set the stand on its feet and level as necessary.
Step 4: Hardware
Though not necessary, we recommend installing any remaining hardware into open holes in the legs. This will reinforce the assembly and allow the stand to be reconfigured to any height in the future.
Specifications
Note| The optional Infinity Tools Caster Set (Item: HDC-001) will add 2-3/4″
overall to the stand height.
---|---
Note| If using the Infinity Tools Z Bracket (Item: 115-054) with the stand at
its lowest settings, the lower round mounting hole may need to be drilled with
a 1/4″ bit using the hole in the upper leg as a guide. This can be done with
the stand fully assembled.
FAQ
- What is the range of adjustable heights for the Heavy Duty Tool Stand?
- The stand can be configured for heights approximately 22-1/4″ – 23-3/4″ / 25-1/4″ – 43-3/4″ with the levelling feet, and 25/28″ – 45″ with the optional caster set, not including the top.
- Are all components necessary for every configuration?
- No, depending on the desired configuration, not all nuts, bolts, rails, and leg sections may be needed.
- Can the stand support a shelf?
- Yes, the centre rails can be positioned to support a shelf.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>