AddBike Carr Dog User Guide

March 20, 2024
AddBike

AddBike Carr Dog User Guide

DIMENSION  INSTRUCTION

This user guide provides basic information about Whe aVVembl\ of Whe Carr\ȇDog modXle on the AddBike+. Please refer to the User and Installation Guide for safety instructions and additional information: https://add- bike.com/wpcontent/uploads/2021/03/Guide-dinstallation.pdf

SCAN ME

Content of the box

**Casting


Cover

**Front textile


Floor mat

Screws BHC M5

Required tool

Allen wrench (size 3)

Summary

Frame

Textile

Fabric attachment and finishing

Installation of the frame

Remove the 4 screws situated on each individual corner of the frame (2 on the backrest and 2 on the seat

Install the compact slat with 4 screws BHC M5x20 at the bottom of the two tubes (as shown on the right).

Insert the assembly just built into the seat by fastening the 2 previously removed screws

Insertion of the textile

Install the textile by inserting the two lower elastic bands into the front tubes.

Insert the 2 upper tubes throughout the elastic straps following the direction shown by the arrow on the right.

Secure the upper tubes by inserting them in the side strap (as shown on the left.

Insert the upper tubes into the backrest and the front tubes and then replace the backrest screws previously removed.

At the back of the frame, attach starting from strap no.1 (image on the left) to no.2 to no.3 followed by the vertical strap no.4 and the horizontal strap no.5

Tighten the fabric on both sides, centering the fabric on the backrest as much as possible.
Verify that no cables from the AddBike+ are caught in the strap clamps.

Insertion of the crossbar into the front textile sleeve.

Proceed by positioning and screwing in the crossbar as shown on the image on the left. The two screws required are BHC M5x30

Fabric attachment and finishing

Assemble the front textile with the Carry’Dog’s cover using the Velcro fasteners

Assemble the floor mat in the bottom of the Carry’Dog by attaching the four press studs

Then assemble the cover by attaching it to the module using the press studs and Velcro fasteners

If you wish to use the Carry’Dog without its lid, you can roll it up and secure it inside the box with the elastic straps.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals