AddBike Plus Cargo Bike Conversion Kit User Guide
- May 15, 2024
- AddBike
Table of Contents
**Add Bike Plus Cargo Bike Conversion Kit User Guide
**
This user guide provides basic information about the assembly of the Carry
‘Box module on the Add Bike+. Please refer to the User and Installation Guide
for safety instructions and additional information: https://add-bike.com/wp-
content/uploads/2021/03/Guide-dinstallation.pdf
Content of the box
Screws BHC M5
Textile parts
- Crossbar
- Front tubes
- Upper tubes
- Compact slat
Required tool
Allen wrench (size 3)
Summary
Frame
Textile
Fabric attachment and finishing
Installation of the frame
Remove the 4 screws situated on each individual corner of the frame of the Add
Bike+ (2 on the backrest and 2 on the seat)
Install the compact slat with 4 screws BHC M5x20 at the bottom of the two
front tubes (as shown on the right)
Insert the assembly just built into the seat of the Add Bike+ by fastening the
2 previously removed screws
Insertion of the textile
Install the textile by inserting the two white sleeves into the front tubes
At the back of the frame, attach starting from strap no.1 (image on the left) to no.2 to no.3
Tighten the fabric on both sides, centering the fabric on the backrest as much as possible.
Verify that no cables from the Add Bike are caught in the strap clamps.
Attach the upper tubes to the front tubes & to the backrest of the Add Bike+
(refer to pg. 2) with the screws previously removed.
Slide the crossbar in the apposite hem of the lid (optional step)
Proceed by positioning and screwing in the crossbar as shown on the image on the right. The two screws required are BHC M5x30
Fabric attachment and finishing
Detach the fold of fabric from the Velcro and fold it over the upper tubes. Secure it again by attaching the Velcro.
Close the Carry ‘Box by positioning the lid on the structure
It you wish to use the Carry ‘Box without its lid, do not slide the crossbar into the apposite hem on the lid during assemblage.