sainlogic GD0701 Professional WiFi Weather Station with Outdoor Sensor User Guide

May 15, 2024
Sainlogic

sainlogic GD0701 Professional WiFi Weather Station with Outdoor Sensor

WiFi Simple Setup Guide

Weather Server Registration Guide

Note: If you have registered the Weather cloud and wunderground account before, only need to create “New Device” to add your new weather station information.

Sign up on Weather cloud.net

Note: You are advised to register on laptop for better experiences.

Sign up onWunderground.com

WiFi Setup of Display Console

Note: When powered up the console, If the WiFi displayed without flashing. Press the Min/Max key 3 seconds until the WiFi word icon is flashing.

Quick Setup Instruction

This instruction helps you verify whether the unit is working properly after unboxing.

Install Batteries for Outdoor Sensor Array

Remove the battery door on the back of the sensor by removing the set screw.

Inserting 3xAA batteries in the battery compartment.

Close the battery door and Tighten the set screw. The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds thereafter. Each time it flashes, the sensor is transmitting data

Plug in Adapter for Indoor Console

The Console will instantly display indoor information, Integrated outdoor sensor data will update on the display within a few minutes. Do not press any buttons until the outside transmitter reports in, otherwise the outdoor sensor search mode will be terminated. When the outdoor transmitter data has been received, the console will automatically switch to the normal mode from which all further settings can be performed. While in the search mode, the remote search icon will be constantly displayed.

Sensors Verification

Put the outdoor sensor array and the indoor console at the same location good ventilating condition.

  1. Verify temperature and humidity. The difference between indoor and outdoor temperatures should be within 4°F/2°C. The difference between indoor and outdoor humidity should be within 10%. Usually the indoor temperature is a little bit higher than outdoor temperature due to warming up effect of the backlight. Let the unit stabilize for at least 30 minutes.
  2. Verify wind speed and wind direction. Spin the wind cup and the wind vane and make sure the wind speed and wind direction information on display updates.
  3. Verifying Rain gauge. Tip the sensor array back and forth several times. You should hear a “clicking” sound within the rain gauge. Verify the rain reading the display console is not reading 0.00. Each “click” represents 0.01 inches of rainfall.
Outdoor Integrated Sensor Installation

Fasten the integrated transmitter to mounting pole brackets with foot- mounting, two ¢3 bolts and M3 nuts. Tighten the mounting pole to your existing mounting polewiththefour¢5 Bolts and M5 Nuts assembly, or fix on the wall with four tapping screw. Please ensure that the outdoor transmitter is fixed particularly tightly, otherwise windy conditions cause the transmitter to shake and thus misread the rainfall data.

Install the sensor array at least four times the distance of the height of the tallest obstruction.

Horizontal Installation

Vertical Installation

Documents / Resources

| sainlogic GD0701 Professional WiFi Weather Station with Outdoor Sensor [pdf] User Guide
GD0701 Professional WiFi Weather Station with Outdoor Sensor, GD0701, Professional WiFi Weather Station with Outdoor Sensor, WiFi Weather Station with Outdoor Sensor, Weather Station with Outdoor Sensor, Station with Outdoor Sensor, Outdoor Sensor
---|---

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals