KYSONA M101GC Wireless Mouse User Guide
- May 15, 2024
- KYSONA
Table of Contents
KYSONA M101GC Wireless Mouse
Power On/Off
- Slide the switch to power on/ off the mouse
Connect up to 3 devices via mode Switching
- Press the mode switch button on the bottom to toggle between.
2.4G mode (red light)
Bluetooth mode 1 (flashing green light)
Bluetooth mode 2 (flashing blue light)
2.4G Mode Pairing
- Enter 2.4G mode, the red light blinks.
- Insert the receiver into USB; it auto-pairs.
- After pairing, red light for 3 seconds, then off.
- If not paired automatically, press left + middle buttons for 3 seconds to reactivate pairing mode.
Bluetooth Pairing
-
In Bluetooth mode, hold the switch button for 3 seconds until slow flashing.
-
Go to the BT settings of your device and find “M101 BT1” or “M101 BT2” to pair and connect.
M101 BT1
Input
M101 BT2
Input -
If the connection was built up, the BT indicator light will automatically turn off.
DPI (Dots Per Inch)
- Change DPI with a press of the DPI cycle button.
- Factory DPI settings: 800, 1200, 1600.
Battery and Sleep
- Red battery indicator light flashes means low power. Insert into USB for charging (Light on means charging. Light off when fully charged.) Light off when fully charged. Low battery: red light flashes during charging, fully charged in about 2 hours.
- Moving the mouse wakes it up from Level 1 sleep mode (inactive for ls to 35s) or Level 2 sleep mode (inactive for 35s to 10mins).
- Pressing a key wakes the mouse up from Level 3 sleep mode (inactive for more than 10 mins).
Quick Support
- Detailed Manual: support.kysona.com/m101gc
- Support Email: service@kysona.com
Read User Manual Online (PDF format)
Loading......