ARKSEN 005-TH-RRS64SA Skinny Roof Rack Cargo Carrier Basket User Manual

ARKSEN 005-TH-RRS64SA Skinny Roof Rack Cargo Carrier Basket User Manual

WARNING:
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, unapproved modification,or neglect of this product.

Thank you for purchasing our product.
This manual covers operation and maintenance information about the product. Read carefully and understand all instruction before using the product.
All information in this publication is based on the latest product information available at the time of approval for printing.
We reserve the right to make changes at any time without notice and without any obligation.

READ ALL INSTRUCTION BEFORE USE

• Inspect the product before use. Do not use if damaged or with missing parts.
• Do not use the product for anything other than intended use.
• Do not exceed the maximum load capacity.
• Always distribute the weight on the rack evenly.
• Always secure the loads on the rack and check frequently.
• Make sure all knobs and screws are tighten before use.
• Do not carry cargo that is larger than the rack.
• Do not carry any flammable or combustible items on the rack.
• Use the roof rack according to your state, or local vehicle regulation.

SAVE THESE INSTRUCTIONS

SPECIFICATION

PACKAGE CONTENT

• Rear Basket 1x
  

• Basket Extension 1x
  

• Front Basket 1x
  

• Washer 8x

• Wing Nut 8x

• Spacer 4x

• U-Bolts 4x

• Bracket Top Plate 4x
  

• Foam Padding 4x

• Nuts 4x

• M6 x 16 mm Screws 10x

• M6 x 35 mm Screws 2x

• Side Fairing 4x

• Front Fairing 1x
  

• Top Clip 2x

• Bottom Clip 2x

• Allen Wrench 1x

ASSEMBLY INSTRUCTION

Slide the basket assembly together.

Secure the assembly using the provided M6 x 16mm screws through the side fairing to the basket frame.

• Assemble the front fairing to the basket

• Install the clip on the rack. The smaller clips fit on the top and the larger clips fit on the bottom.

• Secure the fairing by using 16mm screws through the top clip and the longer 35mm screws through the bottom clips.
  

• The rack can only be installed on vehicles with mounting rail and cross bar.
  NOTE: Check with your vehicle dealership for compatible mounting rail if necessary.

• Position the saddle away from the center of the rack for even weight distribution. Align them to the crossbar on your vehicle.
  NOTE: Relocate the crossbar on the mounting rail if necessary. The 2 crossbars need to be at least 15” apart from each other.

• Clamp and secure the rack on the crossbar by tightening the wing nuts on the saddle.
  

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>