MEAN-WELL PLD-25 Series 25W Single Output LED Power Supply Owner’s Manual

May 15, 2024
MEAN WELL

MEAN-WELL PLD-25 Series 25W Single Output LED Power Supply

MEAN-WELL PLD-25 Series 25W Single Output LED Power Supply

Features:

  • Universal AC input / Full range (up to 295VAC)
  • Built-in active PFC function
  • Constant current design
  • Protections: Short circuit / Over temperature
  • Cooling by free air convection
  • Fully isolated plastic case
  • Class 2 Power Unit
  • Class Il power unit, no FG
  • IP42 design
  • Suitable for LED related fixture or appliance (such as LED Decoration or Advertisement devices)
  • 100% full load burn-in test
  • Low cost
  • High reliability
  • Suitable for dry / damp locations
  • 3 years warranty

GTIN CODE

MW Search: https://www.meanwell.com/serviceGTIN.aspx

SPECIFICATION

MODEL| PLD-25-350| PLD-25-700| PLD-25-1050| PLD-25-1400
---|---|---|---|---
OUTPUT| RATED CURRENT| 350mA| 700mA| 1050mA| 1400mA
OPERATING VOLTAGE RANGE| 40 ~ 58V| 24 ~ 36V| 16 ~ 24V| 12 ~ 18V
CURRENT ACCURACY| ±5.0%
RATED POWER| 20.3W| 25.2W| 25.2W| 25.2W
RIPPLE & NOISE (max.) **Note.1| 4.6Vp-p| 2.7Vp-p| 2.2Vp-p| 2Vp-p
NO LOAD OUTPUT VOLTAGE (max.)| 60V| 50V| 35V| 25V
SETUP TIME| 500ms / 230VAC 2000ms / 115VAC at full load
INPUT| VOLTAGE RANGE| 90 ~ 295VAC 127 ~ 417VDC
FREQUENCY RANGE| 47 ~ 63Hz
POWER FACTOR (Typ.)| PF>0.98/115VAC, PF>0.92/230VAC, PF>0.91/277VAC at full load (Please refer to “Power Factor Characteristic” curve)
TOTAL HARMONIC DISTORTION| THD< 20% when output loading≧70% at 115VAC/230VAC input and output loading≧80% at 277VAC input
EFFICIENCY (Typ.)| 85%| 86%| 85%| 84%
AC CURRENT (Typ.)| 0.6A/115VAC     0.3A/230VAC     0.2A/277VAC
INRUSH CURRENT (Typ.)| COLD START 25A(width=75μs measured at 50% Ipeak) at 230VAC
MAX. No. of PSUs on 16A CIRCUIT BREAKER| 72 units (circuit breaker of type B) / 80 units (circuit breaker of type C) at 230VAC
LEAKAGE CURRENT| <0.5mA / 240VAC
PROTECTION| SHORT CIRCUIT| Hiccup mode, recovers automatically after fault condition is removed.
OVER TEMPERATURE| Shut down o/p voltage, re-power on to recover
ENVIRONMENT| WORKING TEMP.| -30 ~ +60℃ (Refer to “Derating Curve”)
WORKING HUMIDITY| 20 ~ 95% RH non-condensing
STORAGE TEMP., HUMIDITY| -40 ~ +80℃, 10 ~ 95% RH
TEMP. COEFFICIENT| ±0.03%/℃ (0 ~ 50℃)
VIBRATION| 10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
SAFETY & EMC| SAFETY STANDARDS| UL8750, CSA C22.2 No. 250.0-08, ENEC BS EN/EN 61347-1, BS EN/EN 61347-2-13 independent, BS EN/EN 62384, EAC TP TC 004, IP42 approved ; design refer to UL60950-1
WITHSTAND VOLTAGE| I/P-O/P:3.75KVAC
ISOLATION RESISTANCE| I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
EMC EMISSION| Compliance to BS EN/EN55015, BS EN/EN61000-3-2 Class C (≦75% load) ; BS EN/EN 61000-3-3, FCC part 18 non-consumer equipment, EAC TP TC 020
EMC IMMUNITY| Compliance to BS EN/EN61000-4-2,3,4,5,6,8,11, BS EN/EN55024,BS EN/EN61547, light industry level, EAC TP TC 020
OTHERS| MTBF| 5524.2K hrs min.      Telcordia SR-332 (Bellcore) ; 968.2Khrs min.       MIL-HDBK-217F (25℃)
DIMENSION| 845729.5mm (LWH)
PACKING| 0.19Kg; 72pcs/14.7Kg/0.75CUFT
NOTE**|

  1. Ripple & noise are measured at 20 MHz of bandwidth by using a 12″ twisted pair-wire terminated with a 0.1 uf & 47uf parallel capacitor.
  2. Direct connecting to LEDs is suggested, but is not suitable for using additional drivers.
  3. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED power supply can only be used behind a switch without permanently connected to the mains.
  4. The ambient temperature derating of 3.5°CY1000m with fanless models and of 5°C/1000m with fan models for operating altitude higher than 2000m(6500ft).
  5. For any application note and IP waterproof function installation caution, please refer our user manual before using. https://www.meanwell.com/Upload/PDF/LED_EN.pdf
    Product Liability Disclaimer:For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx

Mechanical Specification

Case No.PCD16A

Unit:mm

Mechanical Specification

Block Diagram

fosc: 90KHz(115VAC) 120KHz(230VAC)

Block Diagram

Derating Curve

Derating Curve

Static Characteristics

Power Factor Characteristic

Power Factor Characteristic

EFFICIENCY vs LOAD (PLD-25-700)

PLD-25 series possess superior working efficiency that up to 86% can be reached in field applications.
EFFICIENCY vs LOAD \(PLD-25-700\)

Customer Support

User Manual

QR Code

File Name:PLD-25-SPEC 2023-04-14

Downloaded from Arrow.com.

Symbols

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

MEAN WELL User Manuals

Related Manuals