Zevluck WLA2304-1BLK Matte Black Bathroom Vanity Light Instruction Manual
- May 15, 2024
- Zevluck
Table of Contents
Zevluck WLA2304-1BLK Matte Black Bathroom Vanity Light
Product Information
Specifications
- Model: WLA2304-1BLK
- Manufacturer: Alecchi Lighting Co., Limited
- After Sales Services Email: Zevluck@163.com
Product Usage Instructions:
- Carefully unpack the fixture and all components.
- Disconnect power from the main power distribution board before installation.
- Detach MOUNTING PLATE from BACKPLATE by removing BACKPLATE SCREWS.
- Route power cord, attach MOUNTING PLATE to J-BOX, and secure MOUNTING PLATE by PANHEAD SCREW.
- Connect wires by twisting lamp wire ends and power wires together: black wire to black wire (hot wire).
WARNING: Turn the power off (unplug from the wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to cool down. Do not subject the lamp to any shock while lit as shattering of the lamp may result.
Alecchi Lighting Co., Limited – Professional Instruction
FAQ
-
Q: What should I do if the lamp is flickering?
A: Check the connections to ensure they are secure. If the issue persists, contact After Sales Services via email at Zevluck@163.com for further assistance. -
Q: Can I use a higher wattage bulb than recommended?
A: It is recommended to use the specified wattage bulb to prevent damage to the fixture. Using a higher wattage bulb may lead to overheating and potential hazards.
Assembly Instruction
WLA2304-1BLK Installation & Wiring Instruction
- Carefully unpack the fixture and all components.
- Disconnect powder from the main power distribution board before installation.
- Detach MOUNTING PLATE from BACKPLATE by removing BACKPLATE SCREWS.
- Route power cord, attach MOUNTING PLATE to J-BOX, and secure MOUNTING PLATE by PANHEAD SCREW.
- Connect wire. Twist lamp wire ends and powder wires together: black wire to black wire(hot wire), white wire to white wire(neutral wire), screw on the WIRE NUT, making sure the conductors are not exposed. Connect ground wire to MOUNTING PLATE by using the green hex GROUND SCREW.
- Carefully tuck the wires and wire nuts into J-BOX, attach BACKPLATE onto MOUNTING PLATE and fasten by BACKPLATE SCREWS, then make sure that the lamp fixture is secure on the wall.
- Install GLASS SAHDE. Removing FINIAL under the socket, place GLASS SHADE (a) under the socket, and secure by FINIAL.
- Install bulb into socket, recommend E26 Type T10 bulb (bulb not included).
- Place GLASS SHADE (b) onto socket.
AFTER SALES SERVICES EMAILS: Zevluck@163.com
WARNING: TURN THE POWER OFF (UNPLUG FROM THE WALL OUTLET) BEFORE REPLACING THE BULB. MAKE SURE THE BULB HAS SUFFICIENT TIME TO COOL DOWN. DO NOT SUBJECT THE LAMP TO ANY SHOCK WHILE LIT AS SHATTERING OF LAMP MAY RESULT.
Alecchi Lighting Co., Limited—PROFESSIONAL INSTRUCTION