EEZEE POWER LED Driving Light Instructions
- June 13, 2024
- EEZEE POWER
Table of Contents
EEZEE POWER LED Driving Light
Opticube Driving Light Instructions
If you prefer to use a connector of your choice, you may cut the DT connector off. This does not affect the warranty. Please make sure you remember the cable positions before making the cut so that you know which cable has which function .
PARTS INCLUDED
- A. 1 x Opticube led light
- B. 1 x Universal led light mounting bracket
- C. 1 x M8 stainless steel bolt
- 1 x M8 spring washer
- 1x M8 washer
- 1x M8 nut
- 2x M6 Allen bolts
- 2x M6 spring washer
TOOLS REQUIRED
- Allen keys (included)
- Wrench 14 mm
PARTS REQUIRED
2 PIN DT Deutsch connector (male)
DT Connector
DT Connector wiring position
DT Cable Position| ****
Cable Function
| ****
Cable Colour
---|---|---
1| Driving beam (9-36V DC+)| Red
2| Grounding (Negative – )| Black
Disclaimer
All information in this guide has been prepared with great care. Although we
make every effort to ensure that they are correct, errors may occur. Eezee
Power cannot be held liable for errors, changes, outdated information and/or
omissions.
This user guide aims to assist you in doing your own installations and is for
information purposes only. Eezee Power will not be responsible for any damage
caused by the failure to install the product according to these instructions.
If you do not understand the instructions and/or you do not feel confident
enough to tackle the installation, you should have the product installed by a
professional.
General guidelines
- Never connect this product to a source lower than 9 or higher than 36 Volts.
- Always use a relayed wiring harness. Never connect directly to the battery.
- Use lubrication on all stainless steel hardware to prevent locking.
- Do not open or modify the product without explicit Eezee Power consent.
- Check local regulations in order to legally install and use the product.
- The cooling element on the back heats up when the product is in operation, this is normal.
- Do not use a jet washer on the lamp. Do not use an automatic car wash with lamps installed on the car.
Product care information
- Wash the lamp regularly, just as you would care for your vehicle.
- Hand-wash with a mild soapy water or household glass cleaner to remove dirt, grime and insects.
- Never use dish soap, wax, abrasive cleaners, polishers or products made for normal paints.
- Use a soft wash mitt, cotton cloth or microfiber cleaning cloth. Never use terry cloth or paper towels.
- To enjoy the matte appearance for many years, you can buy a no-shine matte car wash soap.
Warranty
Our warranty only applies to manufacturing or design defects and does not
cover misuse, modification, improper installation, accident damage, normal
wear or finish failure caused by usage of wrong cleaning agents.
Please check the terms and conditions on our website for further details about
the warranty procedures.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>