Zevluck SCA2303-3BLK 3 Light Bathroom Vanity Light User Manual
- June 17, 2024
- Zevluck
Table of Contents
Zevluck SCA2303-3BLK 3 Light Bathroom Vanity Light
Product Information
Specifications
- Model: SCA2303-3BLK/4BLK
- Manufacturer: Alecchi Lighting Co., Limited
- After Sales Services Email: Zevluck@163.com
Product Usage Instructions
Assembly Instructions
- Carefully unpack the fixture and all components.
- Disconnect power from the main power distribution board before installation.
- Detach CROSS BAR from BACKPLATE by removing BACKPLATE NUTS.
- Route power cord, attach CROSS BAR to J-BOX, and secure CROSS BAR by PANHEAD SCREW.
- Connect wires. Twist lamp wire ends and power wires together: black wire to black wire (hot wire).
Important Safety Instructions
Warning: Turn the power off (unplug from the wall outlet) before replacing the bulb. Make sure the bulb has sufficient time to cool down. Do not subject the lamp to any shock while lit as shattering of the lamp may result.
FAQ
Q: How do I replace the bulb in the fixture?
A: To replace the bulb, follow these steps:
- Turn off the power by unplugging the fixture from the wall outlet.
- Allow the bulb to cool down before handling it.
- Remove the old bulb and replace it with a new one of the same type and wattage.
- Securely fasten the new bulb in place and ensure it is properly connected.
- Turn on the power and test the new bulb to ensure it is working correctly.
Q: How can I contact customer service for after-sales support?
A: For after-sales services, you can contact Zevluck at Zevluck@163.com
for assistance with any product-related queries or issues you may encounter.
Installation & Wiring Instruction
- Carefully unpack the fixture and all components.
- Disconnect powder from the main power distribution board before installation.
- Detach CROSS BAR from BACKPLATE by removing BACKPLATE NUTS.
- Route power cord, attach CROSS BAR to J-BOX, and secure CROSS BAR by PANHEAD SCREW.
- Connect wire. Twist lamp wire ends and powder wires together: black wire to black wire(hot wire), white wire to white wire(neutral wire), and screw on the WIRE NUT, making sure the conductors are not exposed. Connect the ground wire to CROSS BAR by using the green hex GROUND SCREW.
- Carefully tuck the wires and wire nuts into J-BOX, attach BACKPLATE onto CROSS BAR, and fasten by BACKPLATE NUTS, then make sure that the lamp fixture is secure on the wall.
- Install GLASS SHADE. Remove the SOCKET RING from the socket, attach LAMP CUP onto the socket, next attach GLASS SHADE onto LAMP CUP, then screw SOCKET RING onto the socket by TONGS, making sure that GLASS SHADE is secure on the lamp fixture.
- Install bulb into the socket, recommend E26 60W MAX bulb (bulb not included)
AFTER-SALES SERVICES EMAILS:
Zevluck@163.com
WARNING : TURN THE POWER OFF (UNPLUG FROM THE WALL OUTLET) BEFORE
REPLACING THE BULB. MAKE SURE THE BULB HAS SUFFICIENT TIME TO COOL DOWN. DO
NOT SUBJECT THE LAMP TO ANY SHOCK WHILE LIT AS SHATTERING OF LAMP MAY RESULT.
Alecchi Lighting Co., Limited
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>