ideal lux Wheel SP3 Wheel Pendant Light 3Lt in White Instruction Manual
- June 17, 2024
- ideal lux
Table of Contents
Wheel SP3
REV 23/ 10/ 2 023
Wheel SP3 Wheel Pendant Light 3Lt in White
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
| Suspension lamp
---|---
| E27 max 3 x 60W / 220~240V
50/60Hz
– 8021696009681 BIANCO
FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION. THE LIGHTING FITTING SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN.
SAFETY INSTRUCTIONS
-
This fitting is produced and tested in accordance with the strictest European safety standards (EN 60.598-1).
-
This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
-
As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
-
If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
-
Always isolate power before commencing installation, maintenance or repair.
-
The luminaire contains certain parts which can be very hot.
-
Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
-
Always tighten the screws firmly to avoid contact problems.
-
This fitting should only be installed indoors.
-
Luminaires not suitable for recessed on normally flammable surfaces.
-
Luminaire not suitable for direct mounting on normal flammable surfaces.
-
This fitting is only suitable for fixing to the ceiling.
-
This fitting is only suitable for fixing to the wall.
-
The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
-
Only use lamps which do not exceed the maximum specified wattage.
-
Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
-
Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing.
-
Cracked or broken safety glass has to be replaced immediately. Use only manufcturer approved parts complying with regulations.
-
Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
-
This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
-
Class I Electrical safety guaranteed by the main insulation and an additional protective conductor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
-
Class II Electrical safety guaranteed by the main insulation and a double or reinforced insulation.
Earthing not necessary. -
Class III Electrical safety guaranteed by very low power supply (less than 50 Volt). Earthing excluded.
-
Not protected.
-
Protected against solid objects greater than 50 mm.
-
Protected against solid objects greater than 12 mm.
-
Protected against solid objects greater than 2,5 mm.
-
Protected against solid objects greater than 1mm.
-
Dust protected.
-
Totally protected against dust infiltration.
-
Not protected.
-
Protected against vertically falling water drops.
-
Protected against water drops falling with a maximum angle of 15° to the vertical axis.
-
Protected against rain.
-
Protected against splashing water.
-
Protected against water jets.
-
Protected against strong water jets.
-
Protected against temporary immersion.
-
Protected against prolonged immersion.
-
Luminaire not suitable for covering with thermally insulating material.
-
Caution, risk of electric shock.
-
Do not stare at the operating light source.
IDEAL LUX s.r.l.
Via Taglio Destro 32
30035 Mirano (VE) Italy
www.ideal-lux.com
IDEAL LUX Warehouse
Via delle Industrie, 8/D
30036 Santa Maria di Sala (Venezia)
8.00 – 12.00 / 13.30 – 17.00