Regalo 1158 Extra WideSpan Walk Through Baby Gate Installation Guide
- May 15, 2024
- regalo
Table of Contents
Regalo 1158 Extra WideSpan Walk Through Baby Gate Installation Guide
Before Assembly
BEFORE USING PRODUCT Read and follow all instructions carefully to ensure that
your gate and extensions are properly installed. Improper installation could
result in the gate becoming unstable or dislodged from the doorway. Always
make sure the extension is securely attached to the gate before using. The
safety of your child is your responsibility. Please keep these instructions
for your reference.
IMPORTANT
- Never use more than two extensions per side of gate.
- If hardware mounting to a surface other than drywall or wood, please consult with a professional about installation.
- Base locks are to be used at all times, on both sides of the gate.
REMOVING YOUR GATE FROM THE WALL To remove your gate from the wall, rotate the adjustment wheels on each of the (4) threaded spindle rods to depressurize the gate from its doorway or opening. Then, gently pull or push the gate free from its doorway or opening.
CARE AND MAINTENANCE Periodically check the gate for signs of damage, wear, or missing components. Do not use if any part is missing, worn or damaged. Check the gate regularly to ensure all the hardware and mountings are tightened. Do not use abrasive cleaners or bleach. Clean by sponging with warm water and a mild detergent.
Assembling and Installing Your Gate
NOTE: You will notice a slight gap between the gate door latch and the frame tube. This is not a defect. Your gate is a pressure mounted gate and this gap will disappear once you tighten your gate in the doorway opening.
NOTE: It may be necessary to hold the threaded spindle rods or rubber feet while rotating the adjustment wheels to ensure the entire unit does not rotate.
NOTE: The gap between the gate and wall should not exceed more than 2.5 inches. Make the appropriate adjustment to ensure you have installed your gate safely.
Operating the Door Latch
NOTE: There should be equal spacing among each of the (4) threaded spindle
rods. Make the appropriate adjustment to ensure you have installed your gate
safely.
NOTE: If your secure lift latch is not properly engaging with the receiving
component, ensure that your gate is level, mounted properly, and that you have
not over-tightened the threaded spindle rods.
NOTE: Place lock down on side occupied by the child.
Positioning and Attaching Wall Cups
Adding a Gate Extension STEP 1
Remove the top and bottom threaded spindle rods. Assemble the gate and
extension as illustrated. Reposition the gate and fit in accordance with the
gate fitting.
NOTE: It is preferable to install any extensions on the hinge side of the
gate.
Replacement Parts
A Hardware Kit #14055 Includes:
Threaded Spindle Rods w/ Adjustment Wheel (4), Spring Loaded Upper Door
Mounting Pin (1), 1″ Wall Mount Screws (4), Frame Assembly Screw (2), Wall
Cups (4), Hex Key (1)
90 DAYS LIMITED WARRANTY If, during the first 90 days after consumer purchase of the item, under reasonable and non-commercial use and conditions of maintenance, it fails while owned by the original purchaser because of the quality of materials or workmanship of finish and assembly, Regalo International, LLC, will replace or repair it at Regalo’s option. PROOF OF PURCHASE REQUIRED.
Need more width? Additional extensions sold separately www.regalo- baby.com
⚠ WARNING
The gap between the gate and wall should not exceed more than 2.5 inches.
NOTE: When installing any gate at its maximum width, use wall cups to ensure
stability and safety.
- Install according to manufacturer’s instructions
- To prevent serious injury or death, securely install gate or enclosure and use according to manufacturer’s instructions.
- Children have died or been seriously injured when gates are not securely installed. ALWAYS install and use as directed using all required parts.
- Never stack gates on top of each other to form a taller barrier. This could result in serious injury or death.
- STOP using when a child can climb over or dislodge the gate.
- Use only with the locking mechanism securely engaged.
- To prevent falls, NEVER use at top of stairs.
- NEVER use to keep child away from pool.
- Intended for use with children from 6 months through 24 months.
- Always ensure the gate is resting against the floor before beginning installation.
- This product will not necessarily prevent all accidents. Never leave child unattended.
- Check the gate regularly to see if all the hardware and mountings are tightened.
- Do not use if any component is missing or damaged.
- Adult assembly required.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>