GABOR TTM-50 70 Inch Flat Panel Screens User Manual
- May 15, 2024
- GABOR
Table of Contents
GABOR TTM-50 70 Inch Flat Panel Screens
Product Information
Specifications
- Model: TTM-50
- Type: Universal Swivel Tabletop TV Stand
- Screen Size Compatibility: 37 to 70 inches
- Weight Capacity: Up to 88 pounds
- Swivel Angle: 35 degrees in either direction
FAQ
- What is the weight capacity of the TTM-50 TV stand?
- The TTM-50 TV stand can support flat-panel TVs weighing up to 88 pounds.
- How much swivel range does the mounting arm offer?
- The mounting arm swivels 35 degrees in either direction for flexible viewing angles.
- Can I adjust the height of my TV on the stand?
- Yes, you can adjust the height and swivel angle of your TV on the TTM-50 stand for the perfect viewing experience.
Thank you for choosing Gabor
- The Gabor TTM-50 is a free-standing TV stand that can support up to 70-inch flat-panel TVs that weigh up to 88 pounds.
- The stand is height and swivel adjustable for the perfect viewing angle.
- Included TV brackets attach to your TV’s VESA holes for a secure hold and extra height adjustment.
Safety Information
Safety Warnings
- Gabor takes no responsibility for any product damage or personal injury resulting from mishandling, incorrect mounting, faulty assembly, or improper use of this product.
- Do not use this product with any flat-panel screen device for uses other than those intended; the exact specifications, size parameters, and weight limits are found both on the product box and in the instruction manual.
- It is recommended that at least two people perform the installation process to prevent injury from mishandling or dropping the product or flatscreen device; proper safety gear and tools must be used at all times when installing this product.
- Mounting surfaces should be sturdy and flat. Do not install this product on a weak, uneven surface.
- Do not assemble or use the stand on structures that are unable to support the weight of the TV and stand.
- Do not assemble or use near a heater, fireplace, or any other source of direct heat energy.
- This product may contain small parts which can possibly pose a choking hazard; keep out of reach of children and pets.
- Excessive exposure to liquids may damage the finish of this product; when cleaning this product, use only a mild detergent solution and quickly wipe dry with a soft cloth.
- Do not exceed the maximum load capacity.
- If this product is missing hardware or there are defective parts, visit www.madebygabor.com or call Customer Service at 212-594-2353.
- All images are for illustrative purposes only.
Product Specifications
- Compatible flat-panel display size: 37 to 70 in. (94 to 177.8 cm)
- Height: 20.6, 18.5, 16.6 in. (52.3, 47, 42.2 cm)
- Max weight capacity: 88.1 lb. (40 kg)
- Weight: 14.2 lb. (6.4 kg)
- VESA mounting pattern: 200 × 200, 300 × 200, 400 × 200, 300 × 300,
- 400 × 300, 400 × 400, 600 × 400
- Material: Steel, Glass
- Base dimensions: 16.6 × 11.1 in. (42.2 × 28.2 cm)
Parts List
Required tool:
- Phillips screwdriver
Parts
Installation Instructions
Preparing the Base and Riser
- Peel off the protective paper from the pads, and press them into place on the bottom of the base.
- Position each pad so it’s approximately 1–1.5 inches (2.5–3.8 mm) from each edge.
Assembling and Attaching the Mounting Arm
Attaching a TV to the Stand
- Make sure the arrow on the bracket is facing up toward the top of your TV.
- A variety of screws are included for different VESA standards on the backs of most displays. Select the appropriate size screws and washers. Hand-thread the screw to determine the correct diameter.
Mounting a TV to the Stand
- It’s highly recommended to perform this step with two people.
- Determining which bracket hooks to use to secure your TV to the stand depends on the size of your TV and preferred height of the screen.
- Once the TV is secured to the stand, use a Philips screwdriver to attach the safety brackets as shown in step 8.
- Make sure the safety brackets are screwed tightly against the bottom of the mounting arm to ensure the stability of the brackets.
- If desired, attach the cable organizers by pressing them into the two sets of holes on the back of the riser.
Adjusting the Angle
- The mounting arm swivels 35 degrees in either direction. Turn the screen for the preferred viewing angle.
- Adjust the swivel tension in the mounting arm by tightening or loosening the top and bottom nuts with the included wrench.
LIMITED WARRANTY
ONE-YEAR LIMITED WARRANTY
This Gabor product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. The warranty provider’s responsibility with respect to this limited warranty shall be limited solely to repair or replacement, at the provider’s discretion, of any product that fails during normal use of this product in its intended manner and in its intended environment. Inoperability of the product or part(s) shall be determined by the warranty provider. If the product has been discontinued, the warranty provider reserves the right to replace it with a model of equivalent quality and function.
This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse, improper installation or maintenance. EXCEPT AS PROVIDED HEREIN, THE WARRANTY PROVIDER MAKES NEITHER ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This warranty provides you with specific legal rights, and you may also have additional rights that vary from state to state.
To obtain warranty coverage, contact the Gabor Customer Service Department to obtain a return merchandise authorization (“RMA”) number, and return the defective product to Gabor along with the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own risk and expense.
- For more information or to arrange service, visit www.madebygabor.com or call Customer Service at 212-594-2353.
- Product warranty is provided by the Gradus Group.
- www.gradusgroup.com
Gabor is a registered trademark of the Gradus Group.
© 2023 Gradus Group LLC. All Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>