MiBOXER PIR1-RF Zigbee Drivers for Motion Instruction Manual

MiBOXER PIR1-RF Zigbee Drivers for Motion

Feature

Motion detection support smart scene automation and intrusion warning

Support to link with one or multi 2.4G lighting series

Support to set “hold time” function

Built-in high sensitive lighting sensor

Strong magnetic mounting method

Flexible 360°angle

Parameter

• Model No.: PIR1-RF
• Battery: CR123A 3V
• Standby Power Consumption: 12μA
• Detection Angle: 120°
• Detection Distance: 7m
• RF: 2.4GHz
• Control Distance: 30m
• Working Temperature: -10~40°C

Description

Battery Installation

Link/Unlink

PIR sensor need to be paired with lights, countless lights can be worked with it.

Linking Code Instructions

1. Power off 10 seconds and power on again.
2. Short press ” SET ” button 3 times within 3 seconds.
3. Lights blink 3 times slowly means linking is done successfully.

Linking failed if light is not blinking slowly, Please follow above steps again.
(Note: Light that have linked can’t link again)

Unlinking Code Instructions

1. Power off 10 seconds and power on again.
2. Short press ” SET ” button 5 times within 3 seconds.
3. Lights blink 10 times quickly means unblinking  is done successfully.

Function Description

Brightness feature while motion detected:
When the sensor detects motion, the light automatically turns on (brightness can be set to “previous brightness” or “100% brightness”).

Light Sense:

• ON: PIR sensor only works in gloomy area
• OFF: PIR sensor works in any place

Night Light:

• ON: bright environment to gloomy environment, light up automatically (brightness is 1%), gloomy environment to bright environment, light off automatically
• OFF: Light is off while motion is not detected in any environment

Hold time while motion detected
(30S / 2 minutes / 10 minutes / 60 minutes):
For example: it will turn on light if motion is detected and activated timer function (30 seconds), the light will be off if new motion is not detected within 30 seconds.

Function setting method

Factory default:

• Brightness feature while motion detected: 100%Hold time while motion detected: 30 seconds Light sence: OFF
• Night Light: OFF

1. Long press “SET” seconds, Indicator flashes quickly to start setting up. (Attention: exited without operation within 10 seconds)
2. Short press the keys, details as following (Refer to the table below for key functions)

**Note***

1. If the night light is in the off state, set the light to “previous brightness” when there is motion detected.
2. If the night light is in the on state, set the light to “20% brightness” when there is motion detected.

Reset to factory settings:
Press and hold the “SET” button for 10 seconds until the indicator light flashes slowly 3 times to confirm the reset.

Remote Controls

Compatible with these 2.4G RF remote controls (Purchased separately)

Installation Direction

1. Location: install it in the area where people usually cross over and distance must be 2m over the ground. As shown below.
2. Stay away from air conditioner, fridge, oven..etc which is easy to affect temperature, don’t display it under sunshine directly.
3. Remove sticker on the back base, fix base holder on suitable position.

Attention

1. Remove battery if don’t often use it, save it in dry and static free condition.
2. Don’t use it near metal or strong hertz area, it will affect communication distace.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>