PANDUIT S2BRK6 Net Access S Type Cable Management Panel Instruction Manual
- June 17, 2024
- PANDUIT
Table of Contents
NET-ACCESS S-Type Cable Management Panel
(Part Numbers – S2BRK6, S2BRK12, S1DR, S2DR, S1LR, S2LR)
INSTRUCTIONS CM615C
© Panduit Corp. 2013
Cable Management Panel (S2BRK6, S2BRK12) Installation
- Center Cable Management Panel vertically on outside of cabinet post at desired location (flat surface of bracket to face inwards)
- Fasten Cable Management Panel to cabinet by passing M5 Torx screws [4 screws for S2BRK6; 6 screws for S2BRK12] through holes of cabinet post into center holes of bracket as shown below.
DETAIL VIEW
-
Cable Management Panel
-
M5 Torx Screws -Use T25 Torx driver
-
Primary Mounting Hole
-
Alternate Mounting Holes
NOTE: Alternate mounting holes are to be used when installing 70”+ POUs on S2BRK6 and S2BRK12 in 42 RU cabinets
FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp
D-Ring (S1DR, S2DR) and L-Retainer (S1LR, S2LR) Installation
- Cable Management D-Rings – Insert mounting tab(s) of L-Retainer into round keyhole slot(s) located on the cable management panel. Slide D-Ring in keyhole slot to engage D-Ring.
- Cable Management L-Retainers – Insert mounting tab of L-Retainer into any keyed mounting slot located on the cable management panel. Slide L-Retainer up or down in keyed slot and engage release tab in adjacent cutout. Pull release tab and reverse the process to remove L-Retainer.
1. D-RING INSTALLATION
- S1DR
- S2DR
2. L-RETAINER INSTALLATION
- Ensure Release Tab is engaged in adjacent cutout
For Instructions in Local Languages and Technical Support:
www.panduit.com/resources/install_maintain.asp
E-mail: techsupport@panduit.com
Phone: 866-405-6654
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>