Signature Hardware 946282-DU Traeger Entry Door Set Installation Guide
- June 17, 2024
- Signature Hardware
Table of Contents
Signature Hardware 946282-DU Traeger Entry Door Set
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing door hardware. Signature Hardware accepts no liability for any damage to the door, or hardware, or personal injury during installation. Observe all local building codes. Unpack and inspect the product for shipping damage. If any damage is found, contact our Customer Relations team via live chat at www.signaturehardware.com or by emailing support@signaturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for
the installation.
NOTE: This door set works on a minimum door thickness of 1-3/4” (44mm)
and a maximum door thickness of 2” (50mm)
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at
www.signaturehardware.com for product and
warranty information, or contact us through live chat or by emailing
support@signaturehardware.com.
HARDWARE INCLUDED
Passage Latch Kit
INCLUDED
TOOLS AND MATERIALS
INSTALLATION
-
Confirm that your door has 2 boreholes drilled into the door. This door set works for both 2-3/8″ and 2-3/4″ backsets. Please check that your deadbolt and passade latch match the backseat.
-
Bore Hole CTC distance: 5 1/2” Bore Hole Size: 2 1/8” Cross Bore Size: 1”
-
Drill a third, 15mm diameter hole located 2-1/4 inches (centre to centre) below the bottom bore hole.
Note: This hole is for mounting the two halves of the hardware together in the final assembly step. -
Insert the passage and deadbolt latch into the appropriate cross bore on the edge of the door using the supplied screws.
-
The passage latch inserts into the bottom hole and the deadbolt latch into the upper hole. Do not tighten screws until installation is complete.
-
Insert the lock housing into the exterior escutcheon plate. Mount the exterior escutcheon plate to the exterior side of the door.
-
Add the interior escutcheon plate to the interior side of the door. The interior assembly and exterior assembly should be to the deadbolt latch and passage latch.
-
Secure both escutcheon plates together and to the door by first installing the two Lock Housing screws.
-
These two screws insert through the interior escutcheon on either side of the thumb latch and fasten back into the lock housing.
-
Install post screw on interior escutcheon plate.
-
Before installing screws, you will need to predrill holes into the door. Install screws into the door through the exterior escutcheon plate using the appropriate hardware.
-
Tighten all fasteners, including screws through the deadbolt and latch bolt on the side edge of the door.
DUMMY INSTALLATION
- Place dummy door knob hardware in location and mark mounting holes with a pencil.
- Drill pilot holes at marked locations
- Secure the dummy knob to the door using provided mounting hardware.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>