SIGNATURE HARDWARE WOODBERRY 941513, 941514 Outdoor Wall Sconce Installation Guide
- June 8, 2024
- Signature Hardware
Table of Contents
WOODBERRY 941513, 941514 Outdoor Wall
Sconce
Installation Guide
WOODBERRY
OUTDOOR WALL SCONCE
SKU: 941513, 941514
WOODBERRY 941513, 941514 Outdoor Wall Sconce
BEFORE YOU BEGIN
We recommend consulting a professional if you are unfamiliar with installing
electric fixtures. Signature Hardware accepts no liability for any damage to
the faucet, plumbing, sink, counter top, or for personal injury during
installation.
Observe all local plumbing and building codes. Unpack and inspect the product
for shipping damage. If any damage is found, contact our Customer
Relations team via live chat at
www.signaturehardware.com or by emailing
support@siganturehardware.com.
GETTING STARTED
Ensure that you have gathered all the required materials that are needed for
the installation.
ADDITIONAL QUESTIONS?
Still need help? Check out our Help Center at
www.signaturehardware.com for product and
warranty information, or contact us through live chat or by emailing
support@signaturehardware.com.
WOODBERRY
CARE AND MAINTENANCE:
To clean, wipe with damp cloth. Do not use abrasive cleaners or cleaners that
contain alcohol.
CAUTION:
Shut off main power supply before cleaning product or changing light bulbs.
All glass is fragile. Use care when handling glass shades and bulbs.
RECOMMENDED TOOLS AND ACCESSORIES
SAVE THIS MANUAL: RETAIN FOR CONSUMER’S USE. READ THESE INSTRUCTIONS
COMPLETELY BEFORE INSTALLING THE PRODUCT: FOR PRODUCT OR INSTALLATIO QUESTIONS
PLEASE CALL CUSTOMER. SERVICE AT 1-800 -221-3379.
INSTALLATION (FIG 1) 
1.
Shut off the power at the circuit breaker and remove old fixture, including the
crossbar.
2.Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3.Thread the 2 Mounting Screws (C) to the Mounting plate (E). (You can adjust
the length of the screws if necessary.)
4. Attach the Mounting plate (E) to the Outlet Box (G) (not supplied) by
using 2 Outlet Box Screws (B).
5.Now connect the electrical wires as follows: Connect the black wire from the
fixture to the black house (hot) wire. Connect the white wire from the fixture
to the white (neutral) house wire. Make sure all wire nuts are secured. You
may wrap the connections with electrical tape. If your outlet has a ground
wire (green or bare copper), connect fixture’s ground wire to it. Otherwise,
connect fixture’s ground wire directly to the mounting plate using the green
screw provided. Tuck the wire connections neatly into the junction box.
6.Attach the Fixture (H) to the Mounting Plate by inserting the 2 Mounting
Screws (C),and then secure with the 2 Cap Nuts (F).
7.To prevent moisture from entering the outlet box and causing a short, use
clear caulking (ie. Indoor/Outdoor Silicone Sealant) to outline the outside of
fixture backplate where it meets the wall leaving a space at bottom to allow
moisture a means to escape.
1.855.715.1800
Singnaturehardware.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>