YITAHOME TLCFLS-6007 4 Light Dining Room Crystal Light Fixture Instruction Manual
- June 17, 2024
- YITAHOME
Table of Contents
CRYSTAL CHANDELIER
Notice：
- Follow the installation instructions. Please confirm all accessories are present before installation.
- Do not fully tighten the screws during initial assembly. Fully tighten screws only once all pieces which are correctly assembled.
- If you encounter any problems during installation, please contact our customer service.
Part list
Installation
Step 1 ： Remove the cylindrical nut ( E ) from Canopy ( L ) . Then attach the
fixed metal plate ( A ) to the outlet box with the mounting screws ( B ) . The
one marked “GND” must face outwards.
Step 2：Cut the length of wire when needed. The remaining wire will be at least
6″ long measured from the top of the canopy ( L ).
Step 3：Pay attention to connecting the wires. Be sure to differentiate between
positive and negative points. Positive to positive, negative to negative, and
ground to ground.
Step 4：Screw the top frame (H), four square tubes(I), and bottom frame(M) by
cylindrical screws(N) tightly as the diagram.
Step 5：Screw the tube(G1) onto the top frame(N), then Tube(G) to tube(G1),
tube(F) to tube(G).
Step 6：Screw the tube(F)onto the swirl on the canopy(L).
Step 7：Hang the long crystal(J) and short Crystal(K) on the top metal
frame(H).
Step 8：Install bulbs. (Bulbs not included).
Note： Just assembly the short rod( F ), it can be used as the ceiling
lamps, too.
CONTACT US:
If you have any questions about the installation of YITAHOME® products,
just contact us at +1(888)-717-8084 from Mon-Fri 8:00 AM-16:30 PM PST /
Saturday 8:00 AM-12:00 PMPST or E-mail us at: [email protected]
Alternative method to contact us(amazon.com orders only)
- Log into your amazon account
- Go to “Your Orders” and find the purchase
- Click on “Contact Seller”