WOODBRIDGE WB1013 Wooden Bathtub User Guide
- June 17, 2024
- WOODBRIDGE
Table of Contents
WOODBRIDGE WB1013 Wooden Bathtub
Specifications
- Brand: Woodbridge
- Model: WB1013
- Material: Wooden
- Color: Chrome Drain, Lid
- Dimensions: 67″ x 59-3/4″ x 31-7/8″
- Weight: 722 lbs
Product Usage Instructions:
- Preparation:
- Ensure you have all the necessary tools listed in the manual.
- Carefully remove the bathtub from its crate/box.
- Do not carry the bathtub by its panel, always use a minimum of 2 people to lift it.
- Installation:
- Set the bathtub on cardboard with a soft blanket on top to protect the surface.
- Install the push pop-up drain properly and check for any leaks.
- Fill the tub with cold water to check for leaks from the drain.
- If leakage is detected, apply plumbing putty or silicone caulk to fix it.
- Final Steps:
- Move the tub away to allow for plumbing installation.
- Adjust and secure the tub rim to ensure a proper fit.
INSTALLATION AND CARE GUIDE
READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT
INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED
BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST
BE OBSERVED FOR SAFE INSTALLATION.
CAUTION!| LIFT REQUIRED 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE
INSTALLATION OF THIS PRODUCT
Limited warrantyis void on any commercial installation We are not responsible for local code compliance for this product. Buildingand plumbing codes may vary from state-to-state inaccordance to your location. We are not responsible for providing any compliance certifications. Under no circumstances we are shall not be liable for any and all incidental damages sustained in connection with this product. Neither manufacture, nor distributor, nor retailer is responsible for water damage or flood caused due to use of this product. Under no circumstances, we shall not beliable for any and all fees cost of installation/reinstallation/removal, subsequent damage or transportation in case of the product defect.
Customer Service Phone: 562-229-0088. (Monday – Friday 9 AM – 5 PM Pacific Time) Or Email: help@woodbridgebath.com
Parts Included:
- Matching Seat x1
- Matching Lid x2
- Pillow x1
- Chrome Pop-up Drain x1
Product Details: Model:
- WB1013 Size: (L)67″ X (W) 31-7/8″ X (H)23-5/8″
- Capacity: 1 person
- Material: Rubber Wood
TOOLS REQUIRED FOR INSTALLATION (NOT INCLUDED)
Inspect the bathtub for any damages. If any damage is found please contact your retailer.
Carefully, remove the tub from it’s crate/box.
Important Note: Bathtub must be carried by a minimum of 2 adult people in
upside down position only. Do not carry the bathtub by its panel. To avoid
scratches or damages to the bathtub be sure to set it on cardboard with soft
blanket on top of the cardboard.
Leak test before final installation
Very Important! Before proceeding with installation, please check that push pop-up drain is properly sealed and tightened. Push the pop-up into a close position and fill the bathtub with cold water and check if drain holds the water or any leaks from the bottom of the drain. Check for any leaks around the drain. (NOTE: Due to surface tension, it is normal for a small amount of water to pool around the drain) If a leakage occurs please disassemble the drain line, you can apply a plumbing putty/silicone caulk tof the leakage.
FREESTANDING INSTALLATION
-
Clean, level and prepare the floor for installation, Place the tub in the exact installed location on the floor and trace the outline of the bathtub with pencil and mark the drain hole location on the floor. Move the tub away so that the plumbing can be installed.
-
Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches on tub rim.
-
Install an 1-1/2″ tail piece along with the corresponing flanged washer and 1-1/2″ nut to thedrain body.
-
Measure and cut the tail piece to the appropriate length to reach the trap adapter When setting the tub drain, insert tail piece with 1-1/2″ slip joint and rubber washer into the trap adapter and tighten properly.
-
Flip the tub over and carefully set the tub into position with tail piece assembly to P-trap and connect to the drain.
-
Fill the tub with water and then drain the tub while inspecting the waste connection below the floor for any leaks. Access from below will be necessary for this step.
Note: If installing on a concrete slab where no underfloor access or cannot move drain. You may consider following option.
- Optional flexible drain hose from plumbing hardware or home improvement store may be used (Woodbridge will not supply this flexible hose). Connect one end attaches to the bathtub drain and the other end needs to be attached to the floor drain by using a transition piece.
- Optional Island tub drain may also be used.
- Create a bridge from bathtub drain to floor drain by certified plumber only because any mis-joint or loosen on connection will cause leaks.
INSTALLATION ON SLAB FLOOR (NO UNDERFLOOR ACCESS) /OOD,
-
Clean, level and prepare the floor for installation, Place the tub in the exact installed location on the floor and trace the outline of the bathtub with pencil and mark the drain hole location on the floor. Move the tub away so that the plumbing can be installed.
-
Turn bathtub upside down and set it on a non-abrasive mat, blanket, or cardboard to prevent any scratches on tub rim.
-
Measure the actual distance from drain into drain pipe(not provided)on floor and the drain pipe should extend approximately 1″ above the finish floor. Use a drain adapter (not provided) if necessary.
-
Clean the surrounding of the drain pipe with cloth in preparation of setting the drain, the area should be dry and free of any debris. Apply a bead of clear silicon or plumber putty around the drain body and pass it through the drain hole, also apply plumber putty to the washer and slide it over the bottom of the drain body.
-
Install 1 ½” rubber slip gasket over the drain waste vent.
IMPORTANT SAFETY RULES ATTENTION!
ALWAYS FOLLOW THESE PRECAUTIONS WHEN USING A BATHTUB A Warning The bathtub
must be installed and used as described in this manual
- Warning Use caution when entering or exiting the bathtub 4
- Warning Do not permit children or persons with infirmities to use the bathtub without supervision of an adult
- Warning People using any medications or having adverse medical history must consult a physician prior to use of the bathtub to avoid potential hyperthermia and possible drowning
- Warning Water temperature over 100°F may cause hyperthermia and/or other health problems. Check water temperature and adjust it for your personal comfort
- Warning Never use bathtub while intoxicated, after taking meals or any alcoholic beverages. Consuming alcoholic beverages before or during bathing will cause drowsiness and may result in hyperthermia, loss of
- consciousness, or even drowning
- Warning If you are pregnant or you feel that you are may be pregnant, consult your doctor before using the bathtub
- Warning Never use any electrical devices such as hair dryer, lamp, telephone, tv, radio, or others within 5 feet of the bathtub
- Warning Do not overfill the bathtub before entering. Entering the bathtub when filled will cause overflow and slippery conditions. Use extreme caution when entering and exiting
IMPORTANT!
DO NOT USE: Abrasive cleaners such as: acid, ammonia, bleach, and similar
solutions. Use of such solutions may cause corrosion, finish peeling, and/or
dull the surface.
DO NOT USE: Abrasive sponges or cloth. Never use steel, wool, or wired brushes
that will permanently scratch the surface.
Retain these installation instructions for future reference!
Thank you for using WOODBRIDGE products!
Please don’t hesitate to contact us if you have any questions or concerns. Customer Service Phone: 562-229-0088. (Monday – Friday 9 AM – 5 PM Pacific Time) Or Email: help@woodbridgebath.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>