Tot Mate TM2125R Toddler Play Center Instruction Manual

: June 17, 2024
: ToT mate

Table of Contents

Tot Mate TM2125R Toddler Play Center
HARDWARE / TOOLS INCLUDED
PARTS for TM2125R
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Tot Mate TM2125R Toddler Play Center

Tot Mate-TM2125R-Toddler-Play-Center-product

CAUTION – CHOKING HAZARD
Adult assembly is required due to the presence of small parts and sharp edges.

ATTENTION
Please unpack and assemble in an area away from children’s activities. Remove all tools and excess materials from the work area after the assembly of the unit is complete. Dispose of pallets and packaging materials in an environmentally friendly manner. If any parts are missing or damaged, please call Stevens for immediate parts replacement (1-800-350-3270). When ordering parts, give the Model Number and Colour of the unit.

Illustrations and part numbers are for TM2125R
Basic assembly instructions are the same for the models shown. 2-Person assembly recommended.

NOTE
Refer to the exploded drawing for the orientation of holes to parts.

IMPORTANT!
Be sure to keep all parts supported during assembly to avoid damage. Do not over-tighten bolts or it will damage the pre-drilled holes. The Snug fit is adequate.

HARDWARE / TOOLS INCLUDED

(Phillips screwdriver required but not included.)

Tot Mate-TM2125R-Toddler-Play-Center-fig-1 Tot
Mate-TM2125R-Toddler-Play-Center-fig-2

PARTS for TM2125R

STEP 1: Lay one End (1) flat on the floor, with the side having the most holes facing up.
NOTE: Raw edge is top edge.
STEP 2: Insert the dowel on Rail Support (4) into the lower hole at the top of End (3). Press firmly into place.
STEP 3: Insert dowels on one end of Bottom (2) into the remaining holes on End (3). Press firmly into place.
STEP 4: Position the other End (3) on top of the assembly, so dowels on Rail Support (4) and Bottom (2) align with holes on End (3). Press firmly in place.
STEP 5: Secure End (3) to Rail Support (4) and Bottom (2) with three Confirmat Bolts (10) using the included Hex Wrench.
STEP 6: Carefully turn the assembly over, so the other End (3) is facing up.
STEP 7: Repeat Step 5 to secure End (3) to Rail Support (4) and Bottom (2).
STEP 8: Carefully stand the unit upright and align holes in the Top (1) with dowels on the top edge of Ends (3), making sure the pre-installed Lego Plate (5) is facing up. Press Top (1) firmly into place.
STEP 9: Secure Top (1) to Ends (3) with four Confirmat Bolts (10).
STEP 10: The 4-piece Gear Block Grid (8) fits onto the Lego Plate (5), or can be set aside for later use. Trays (6) are included for storage on the lower shelf.
STEP 11: Ensure that all joints and bolts are tight. This completes the assembly.