STARLEAD UKM3111-12070TDM Bathroom Mirror with Light User Manual

STARLEAD UKM3111-12070TDM Bathroom Mirror with Light

Product information

Specifications

• Size: TS
• Input: SD AD
• Power: STARLEA STARLE Ra >80
• LED : Lumens: CCT:

Kit’s Coming with the Mirror

• Expansion Tube 3+1
• Screw 3+1
• Junction box 1

Tools needed for installation

• Pencil
• Screwdriver
• Rubber Mallets
• Electric drill
• Tape measure

Installation Steps

1. Measure the distance between the two brackets on the back of the mirror and mark the same distance on the wall using a level.
2. Drive the plastic anchors into the hole drilled with an electric drill, then screw the screws into the plastic anchors using the electric drill.
3. Connect the wall power cord to the wires behind the mirror through the junction box.
4. Align brackets behind the mirror with the screws on the wall and hang it to complete installation.

Instructions for use

• The mirror is equipped with 3 touch sensor switches. When installation is finished and power is connected, the touch sensor light will be on. It can be turned off by a long press when the light is on.
• The first touch sensor is for the light. One click for light on/off, long press for dimming.
• The second touch sensor is for the demister pad. Turn it on before a shower to prevent fogging. Turn it off before leaving.
• The third touch sensor is for…

FAQ (Frequently Asked Questions)

How do I turn off the touch sensor light?
You can turn off the touch sensor light by performing a long press when the light is on.

Technical information

• Size: 120x70cm
• Input: 220V
• Power: 70W
• Ra: >80
• LED: SMD2835/499PCS
• Lumen: 1500LM
• CCT: 6500K

Kits coming with the mirror

Tools needed for installation

Installation steps

1. Measure the distance between the two brackets on the back of the mirror and use a level to mark the same distance on the wall.

2. Use a hammer to drive the pastic anchors into the hole drilled with an electric drill, then use the electric drill to screw the crews into the plastic anchors.

3. Connect the wall power cord to the wires behind the mirror through the junction box.

4. Align brackets behind the mirror with the screws on the wall and hang it, installation is completed.

Instructions for use

The mirror is equipped with 3 touch sensor switch, when installation finished and power connected, the touch sensor light will be on, it can be turned off by long press when the mirror light is off.

• For LED Light
  First touch sensor is for the LED light, one click for light on/off, long press for dimming.

• For Demister Pad
  Second touch sensor is for the demister pad, before having a shower we can turn it on, when we finish the shower, the demister pad area would be clear without any fog. Turn if off before leaving.

• For LED Magnifying Mirror
  Third touch sensor is for lighting up the magnifying mirror,one click for light on/off. The magnifying mirror with light can zoom on your facial features when putting eyeliner, eyelash, lipstick and shaving, make sure that every detail of your hair and makeup are appropriate.

Warning

1. Disconnect from outlet before putting on or taking off parts.
2. Close supervision is necessary when this mirror is used by, or near children.
3. Keep the cord away from heated surfaces.
4. Make sure that the electricity is turned off at the power source before proceeding with the installation.
5. Always unplug all the power supply cords from before moving the product, testing the product, or repairing the product.
6. Do not use outdoors.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>