STARLEAD UKM3111 LED Mirror Installation Guide
- June 16, 2024
- STARLEAD
Table of Contents
STARLEAD UKM3111 LED Mirror Installation Guide
LED MIRROR
MANUFACTURER SPECIALIZED IN: LED wall mounted vanity mirror, LED full length mirror, LED mirror cabinet.
Specifications
- Size: 60X60cm
- Input: AC
- Power: 32W
- Ra >80
- LED: SMD2835/402PCS
- Lumen: 2000LM
- CCT: 6500K/3000K/4000K
Kits coming with the mirror
Tools needed for installation:
- Pencil
- Screw Driver
- Rubber Mallet
- Electric Drill
- Tape Measure
Product Usage Instructions
Installation steps:
Measure the distance between the two brackets A on the back of the mirror and use a level to mark the same distance on the wall.
Use a hammer to drive the plastic anchors into the hole drilled with an electric drill, then use the electric drill to screw the screws into the plastic anchors.
Connect the wall power cord to the wires behind the mirror through the junction box.
Align brackets behind the mirror with the screws on the wall and hang it, installation is completed.
Instructions for use:
The mirror is equipped with 3 touch sensor switches. When installation is finished and power is connected, the touch sensor light will be on. It can be turned off by long pressing when the light is off.
FOR LED LIGHT
The first touch sensor is for the light. One click turns the light on/off, and long press enables dimming.
FOR DEMISTER PAD
The second touch sensor is for the demister pad. Before having a shower, we can turn it on. When we finish the shower, the demister pad area would be clear without any fog. Turn it off before leaving.
FOR LED MAGNIFYING MIRROR
The third touch sensor is for adjusting the color temperature. One click changes the color temperature between 6500K, 3000K, and 4000K.
Warning
- Disconnect from outlet before putting on or taking off parts.
- Close supervision is necessary when this mirror is used by, or near children.
- Keep the cord away from heated surfaces.
- Make sure that the electricity is tumed off at the power source before proceeding with the installation.
- Always unplug all the power supply cords from before moving the product, testing the product, or repairing the product.
- Do not use outdoors.
FAQ
Q: What are the dimensions of the LED mirror?
A: The dimensions of the LED mirror are 60X60cm.
Q: What is the power input for the LED mirror?
A: The power input for the LED mirror is AC.
Q: How many touch sensor switches does the mirror have?
A: The mirror has 3 touch sensor switches.
Q: How do I adjust the color temperature of the LED mirror?
A: To adjust the color temperature, use the third touch sensor switch. One click changes the color temperature between 6500K, 3000K, and 4000K.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>