STARLEAD UKM3111-12070TDM LED Mirror User Guide
- June 17, 2024
- STARLEAD
Table of Contents
STARLEAD UKM3111-12070TDM LED Mirror
Specifications
- Size: 80X80cm
- Input: AC Power
- Power: 50W
- Ra: >80
- LED: SMD2835/546PCS
- Lumen: 2700LM
- CCT: 6500K/3000K/4000K
Product Usage Instructions
Tools Needed for Installation
- Pencil
- Screw Driver
- Rubber Mallet
- Electric Drill
- Tape Measure
Installation Steps
- Measure the distance between the two brackets A on the back of the mirror and mark the same distance on the wall using a level.
- Drive the plastic anchors into the hole drilled with an electric drill and screw the screws into the plastic anchors.
- Connect the wall power cord to the wires behind the mirror through the junction box.
- Align brackets behind the mirror with the screws on the wall and hang it to complete installation.
Instructions for Use
The mirror is equipped with three touch sensor switches:
- First touch sensor: One click for light on/off, long press for dimming.
- Second touch sensor: For the demister pad, turn it on before showering to prevent fogging.
- Third touch senso r: Connect the wall power cord to the wires behind the mirror through the junction box.
FAQ
-
Q: Can I adjust the brightness of the light on the mirror?
A: Yes, you can adjust the brightness by long-pressing the light touch sensor switch. -
Q: How do I prevent fogging on the mirror?
A: Use the second touch sensor switch to activate the demister pad before showering to keep the mirror clear of fog.
MANUFACTURER SPECIALIZED IN : LED wall mounted vanity mirror, LED full length mirror, LED mirror cabinet.
Technical information
Kits coming with the mirror
Tools needed for installation
Installation steps
- Measure the distance between the two brackets on the back of the mirror and use a level to mark the same distance on the wall.
- Use a hammer to drive the pastis anchors into the hole drilled with an electric drill, then use the electric drill to screw the crews into the plastic anchors.
- Connect the wall power cord to the wires behind the mirror through the junction box.
- Align brackets behind the mirror with the screws on the wall and hang it, installation is completed.
Instructions for use
The mirror is equipped with 3 touch sensor switch, when installation finished and power connected, the touch sensor light will be on, it can be turn off by long press when the light is off.
-
For LED Light
First touch sensor is for the LED light, one click for light on/off, long press for dimming -
For Demister Pad
Second touch sensor is for the demister pad, before having a shower we can turn it on, when we finish the shower, the demister pad area would be clear without any fog. Turn if off before leaving. -
For LED Magnifying Mirror
Third touch sensor is for lighting up the magnifying mirror, one click for light on/off. The magnifying mirror with light can zoom on your facial features when putting eyeliner, eyelash, lipstick and shaving, make sure that every detail of your hair and makeup are appropriate.
Warning
- Disconnect from outlet before putting on or taking off parts.
- Close supervision is necessary when this mirror is used by, or near children.
- Keep the cord away from heated surfaces.
- Make sure that the electricity is turned off at the power source before proceeding with the installation.
- Always unplug all the power supply cords from before moving the product, testing the product, or repairing the product.
- Do not use outdoors.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>