Target Shower Caddy Corner Tension Pole Stainless Organizer Instruction Manual
- June 17, 2024
- Target
Table of Contents
Target Shower Caddy Corner Tension Pole Stainless Organizer
Warning
- Install in a clean, dry, and safe environment.
- Do not stand on the tub ledge.
- Assemble on the floor.
- Please identify all parts and hardware.
- Place the part on a soft surface to prevent surface scratches.
Tools needed
Product Accessories
Measurement
Use tubes: A + B +
Please measure the space height before installation.
- Keep the ring plastic parts in the end position, This ring-shaped piece of plastic has a slit in it, pinch the sides of the slit to make the slit smaller, and allow the ring plastic part to enter the D pole.
- A & D can be telescoped to adjust the height when combined. The adjustable range is 0 – 9.25 inch
- After adjusting to the desired height, hold the body of the tube where A meets D and rotate it so that they are secure. It can be adjusted again later if necessary.
- The adjustable range is 0 – 9.25 inches Assemble the poles according to the direction Select the required number of tubes according to the actual height (refer to page 3 of the manual) A and B are fixed in the top and bottom positions. C and D are positioned between A and B with the slotted end down.
- Place the shelves on the poles and fit the top and bottom with E.
- At this point, the shelves are naturally stacked at the bottom of the poles and we will install the shelves in the final step.
Secure the pole to the desired mounting location
Place the assembled pole at an inclined angle to the mounting position, push
against the top spring and push the bottom half until the pole is vertical.
Note: The final height of the Corner Shower Caddy needs to be 1 inch
higher than the actual measured height, which is beneficial for placement.
We can install and adiust the shelves after fixina the pole.
- Wrap the part closely adjacent to the steel pipe and basket ring joint with silicone tape (direction arrow pointing up)
- Use your fingers to secure the silicone and move the steel pipe or basket to ensure the silicone tape is fully inserted into the steel ring of the basket
How to firmly install shelves?
First, move the shelves onto the pole to the position where they need to be
fixed, use the rubber piece, pay attention to the arrow direction facing
upwards, and then insert it into the joint between the circular hole of the
shelves and the pole, which can make the shelf stable.
How to firmly install the pole between the ceiling and the ground?
We suggest that the assembled height be 1 inch higher than the actual required
height. This can make the spring pole work better.
What if the assembled poles are too high or too short?
- If the assembled pole is too high, you can reduce the telescopic height between the top spring pole A and the adjacent standard pole D by adjusting it.
- You can recall that the top spring pole A and the connected pole D are combined by rotation, and you reverse torsion them to loosen them. Since the bottom diameter of the top spring pole is smaller than the connected pole D, you can adjust the combination height of spring pole A and pole D, shorten it to the actual required height, and thenrotate and tighten it again. (Refer to Step 1 on page 4)
- If the assembled poles are not high enough, you can flexibly add standard pole D or shorter pole C. If the assembled poles are too high after adding, you can refer to the above suggestions and adjust and shorten the combined height of spring pole A and pole D
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>