PHOENIX ECO8 Gravity Water Filters Instruction Manual
- June 17, 2024
- Phoenix
Table of Contents
ECO8 Gravity Water Filters
Instruction Sheet
Phosnix Gravity Carbon Fifer Cartridge
Before use, your Carbon Cartridges must be primed
Priming is a simple process which flushes the carbon filter cartridge of any
residual sediment from the manufacturing process. These particles are
completely safe but may be blocking the pores which could lead to slow flow
and cloudy water.
Before you start: Cleanliness is key Wash hands before proceeding and
ensure contamination does not take place while priming/cleaning the
cartridges. Ensure all packaging is removed and unscrew two washers and
wingnut from the thread of each carbon filter cartridge.
How to Prime:
Step 1. Screw the wing nut- flat face upwards- onto the filter thread and
place a washer over it. Firmly press the washer flush against the a spigot
spout.
Step 2. Turn on the Spigot [cold water ONLY) to a slow flow- producing
water beads on the surface. Hold in place for 2-3 minutes allow the cartridge
to become fully saturated and flushed.
Priming of Phoenix Gravity Carbon cartridges:
Assembling into Phoenix Gravity Water Filter System:
Push first Washer along the thread of the carbon filter cartridge. Insert the
cartridge thread through any free hole in the upper chamber. The washer should
st flush against base with thread exposed through hole. To the exposed
thread slide on second washer to base. Securely screw on the wingnut snugly
against washer.
Important: Do not over-tighten Repeat for each cartridge. Important:
Check seals to ensure proper water purification:
Each cartridge must have two washers fitted a5 indicated in Step 5.
All holes without cartridges must have a hole blockers. You’re now ready to
start filtering, soe overleaf
Before use: discard first two rounds of filtered water. If primed
incorrectly, you many need to discard up to 4 rounds of filtered water- until
it runs clear.
Maintenance
After 312 months (usage dependant) your cartridge flow-rate may significantly
reduce. This is completely normal- due to either clogging or drying out.
Simply clean to restore flow-rate.
To Clean
Remove unfiltered water from Upper Chamber to make sure none spills into Lower
Chamber. Then remove filters. Lightly scrub each filter under running cold
water using a soft brush or scourer. Always bush away from threaded mount to
ensure it doesn’t get contaminated.
Re-assemble the filters back into the Upper Chamber.
DO NOT use soap or detergents.
A better way to drink water
https://qr1.be/MNBF
Register your product.
Simply scan the QR code above and follow the warranty registration link:
For details, T &Cs and further support:
phoenixwaterfilters.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>